Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Cables To Go
A 2.5 ft Cat6 patch cable with snagless RJ-45 connectors and a 36% slimmer 28AWG design meeting the ANSI/TIA-568-C.2 standard
This 2.5 ft Cat6 patch cable connects two RJ-45 network devices in close proximity. Its snagless moulded boots protect the locking tabs during frequent insertion and removal. The slim 28AWG construction reduces cable bulk by 36 percent compared with standard Cat5e cables. It meets the ANSI/TIA-568-C.2 standard for patch-cord performance.
At 2.5 ft the cable suits rack-to-rack or desk-to-wall links where devices sit side by side. It cannot span a room, cross a ceiling void or reach a distant switch without a longer run. The unshielded design is adequate for typical office or home electromagnetic environments. For longer distances or high-interference areas a different length or shielded category cable is required.
The moulded snagless boot covers the RJ-45 latch so it will not catch on adjacent cables or panel edges. This single mechanical feature determines whether the connector survives repeated moves in dense patch panels or tight cable trays. If the installation never disturbs the cable after seating, the snagless benefit is less critical.
| Brand | C2G |
|---|---|
| Model | 01075 |
| Type | Consumer Electronics |
| Cat | 6 |
| Connector A | RJ-45 Male |
| Connector B | RJ-45 Male |
| Length | 2.50 ft. |
| Color | Blue |
| Shielded | No |
| Features | 36% reduction in diameter compared to standard Cat5e cables Snagless connector design Meets the ANSI/TIA-568-C.2 standard for Patch Cord Performance 28AWG construction |
| Shipping weight | 0.23 kg |
| Package size | 152 × 102 × 51 mm |
Yes, Cat6 is backward compatible with Cat5e infrastructure; the 28AWG conductors meet the ANSI/TIA-568-C.2 patch cord standard for gigabit speeds.
Run a cable certifier or the switch’s built-in cable diagnostic; a pass on the ANSI/TIA-568-C.2 test confirms the 28AWG link meets Cat6 patch cord limits.
The snagless moulded boots are already fitted on both RJ-45 ends; nothing else is included and no separate accessories are required for installation.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?