We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aqua 8ft Cat6a shielded patch cable with snagless RJ45 connectors

Cables To Go

Cables To Go 00747 Cat6a Shielded Network Connector 8ft Aqua

SKU CH-7V91-A03DX MPN 00747

Shielded Cat6a patch cable with RJ-45 connectors for 10 Gigabit network links, tested to ANSI/TIA 568 C.2 standards

  • Supports 10 Gigabit speeds with Cat6a 10GBase-T rating
  • Shielded twisted-pair construction reduces electromagnetic interference
  • Snagless boot design protects RJ-45 locking tabs during installation
  • Aqua colour enables quick visual identification in dense racks
  • Individually labelled length simplifies cable management and tracing

Cat6a shielded patch cable 8 ft

This eight-foot Category 6a patch cable uses shielded twisted-pair construction and RJ-45 male connectors on both ends. It is built for 10GBase-T links and tested to ANSI/TIA 568 C.2 component requirements. The aqua jacket allows quick visual identification in dense racks. Snagless boots protect the locking tabs during frequent moves.

Suited for 10 Gigabit Ethernet runs

The cable suits installers who need a pre-terminated, shielded link for 10 Gigabit switches, routers, servers or patch panels. Bonded pairs keep twist spacing consistent to the termination point. Buyers who need unshielded UTP cable, a different length, or fibre connectivity should select another product.

Sustained 10GBase-T performance

Shielding and bonded-pair geometry suppress alien crosstalk and maintain impedance control over the full run. The design reduces near-end crosstalk and structural return loss during continuous high-throughput traffic. Each unit carries an individual length label for traceability in managed installations.

Highlights

  • Supports 10 Gigabit speeds with Cat6a 10GBase-T rating
  • Shielded twisted-pair construction reduces electromagnetic interference
  • Snagless boot design protects RJ-45 locking tabs during installation
  • Aqua colour enables quick visual identification in dense racks
  • Individually labelled length simplifies cable management and tracing

Specifications

No published specifications for this item yet.

Questions about this item

What devices do I need that have RJ-45 ports to use this Cat6a cable?

You need network equipment such as switches, routers, patch panels or network adapters fitted with RJ-45 jacks that support 10GBase-T operation.

Will this shielded Cat6a cable work with my existing Cat5e or Cat6 patch panels and switches?

Yes, the RJ-45 connectors are backward compatible so the cable will link to older Cat5e or Cat6 ports, though the link will run at the lower category's speed.

How can I verify the cable meets the ANSI/TIA 568 C.2 Cat6a component requirements after installation?

Each cable carries an individual length label and has been fully tested by the manufacturer to meet the ANSI/TIA 568 C.2 Cat6a component standard.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.