We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black sleeved cables with Molex and three fan connectors

Cable Matters 2-pack Molex to 3/4-pin fan adapter 10.6 inch

SKU CH-MCWV-50KNB

A two-pack of 10.6 inch cables powers up to three 3-pin or 4-pin case fans from one Molex connector without PWM control

  • TypeSpeaker Wires
  • ColorBlack
  • Connector DetailDVI to DVI
  • Terminal GenderFemale to Female
  • SpecificationsMolex to 4 Pin Fan Adapter Cable, Black, 0.018 kilograms
  • ConductorCopper Conductor
  • Powers three case fans from one Molex connector
  • 27 cm cable reaches fans across the chassis
  • Two adapters included for multiple cooling zones
  • Copper conductors deliver reliable 12 V power
  • Black high-density sleeving keeps the build looking clean

Two-pack Molex fan splitter for case cooling

This two-pack of Molex-to-fan adapters powers up to three 3-pin or 4-pin case fans from a single Molex connector. Each cable uses a 2-pin Molex plug and three 2-pin fan headers, delivering fixed 12 V power without PWM control. Copper conductors and black sleeving provide a clean internal appearance.

Replaces direct motherboard fan headers when ports

Use these splitters when motherboard fan headers are exhausted or when a fan controller lacks enough outputs. The 10.6 inch length reaches most chassis fan locations from a standard power supply Molex run. The jump is worth it when you need multiple fans on one rail and do not require speed reporting or PWM regulation.

Suits builders adding fixed-speed chassis fans

Ideal for systems that run fans at constant voltage and do not need motherboard speed curves. Not suited for users who require PWM control, tachometer feedback, or variable fan curves tied to temperature sensors. Buyers needing per-fan speed management should look at a powered fan hub or motherboard headers.

Highlights

  • Powers three case fans from one Molex connector
  • 27 cm cable reaches fans across the chassis
  • Two adapters included for multiple cooling zones
  • Copper conductors deliver reliable 12 V power
  • Black high-density sleeving keeps the build looking clean

Specifications

BrandCable Matters
TypeSpeaker Wires
ColorBlack
Connector DetailDVI to DVI
Terminal GenderFemale to Female
SpecificationsMolex to 4 Pin Fan Adapter Cable, Black, 0.018 kilograms
ConductorCopper Conductor
FeaturesMolex to 4 Pin Fan Adapter Cable, Black
Disclaimernot_applicable

Questions about this item

Will the 10.6 inch cables reach fans at the top of a mid-tower case from a bottom-mounted PSU?

The 27 cm length works for typical mid-tower routing from a bottom PSU to top-mounted fans; measure your specific path before ordering.

How do I connect the Molex end without losing a drive power connector?

Plug the adapter into any free Molex lead from the PSU; the pass-through design leaves the original connector available for a drive or another adapter.

Do the fan connectors wear out if I swap fans often?

The copper terminals are rated for repeated mating cycles; avoid angling the plug during removal to keep the pins straight.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.