We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Orange duplex fiber patch cable with LC and ST connectors, 3m length

Cable Leader

Cable Leader OM2 LC-ST Duplex 50/125 3m Orange OFNR Corning

SKU CH-A6HG-NVG4N

Multimode duplex OM2 patch cable with LC to ST connectors for 1G and 10G short-reach links over 50/125µm Corning fiber in a 3m orange OFNR jacket

  • ColorOrange
  • Length5 - 10 ft.
  • Connector Number2
  • Genuine Corning fiber ensures consistent, reliable optical performance
  • LC/UPC ceramic ferrules with push-pull latching deliver secure, low-loss connections
  • Supports 1000BASE-SX and 10GBASE-SR for Gigabit and 10G short-reach links
  • OFNR riser-rated jacket suits in-building and data center installations
  • Duplex 50/125 µm OM2 design keeps transmit and receive fibers paired

OM2 LC-ST Duplex Patch Cable

This 3-metre orange jumper uses genuine Corning 50/125 µm multimode fiber terminated with LC/UPC and ST/UPC connectors. The OFNR riser-rated jacket is approved for in-building and data-centre runs. It ships new and ready for 1000BASE-SX or 10GBASE-SR links up to 10 metres. The duplex construction keeps transmit and receive fibres paired and correctly oriented.

Replaces older OM1 or single-mode jumpers

When your existing patch cords limit 10G short-reach distance or show high insertion loss, this OM2 cable restores full 10GBASE-SR headroom over 10 metres. The precision ceramic ferrules and push-pull latching give repeatable low-loss mating that worn or lower-grade connectors cannot. It is not for buyers who need OM3/OM4 bandwidth or single-mode reach.

Check connector types and jacket rating

Verify that both ends of your link accept LC and ST connectors with UPC polish. Confirm the pathway requires OFNR riser rating rather than plenum or outdoor grades. Ensure the 3-metre length reaches between your transceivers, switches or patch panels without excess slack. The duplex polarity must match your equipment port mapping.

Highlights

  • Genuine Corning fiber ensures consistent, reliable optical performance
  • LC/UPC ceramic ferrules with push-pull latching deliver secure, low-loss connections
  • Supports 1000BASE-SX and 10GBASE-SR for Gigabit and 10G short-reach links
  • OFNR riser-rated jacket suits in-building and data center installations
  • Duplex 50/125 µm OM2 design keeps transmit and receive fibers paired

Specifications

BrandGENERIC
ColorOrange
Length5 - 10 ft.
Connector Number2

Questions about this item

What connectors do I need on my equipment for this LC-to-ST duplex cable?

One end has an LC/UPC connector and the other an ST/UPC connector; both use precision ceramic ferrules with push-pull latching for low-loss mating.

How do I install this 3 m patch cable without damaging the ferrules?

Remove dust caps, inspect and clean each ferrule with a lint-free wipe and isopropyl alcohol, then insert straight until the LC latch clicks and the ST bayonet locks.

When should I replace this OM2 jumper in a 10GBASE-SR link?

Replace it if insertion loss rises above your link budget, if the OFNR jacket shows cuts or kinks, or if a visual fault locator reveals a break in the 50/125 µm Corning fiber.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.