We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Yellow Cat5e Ethernet cable, 50 ft, non-booted RJ45 plugs, 24 AWG bare copper

Cable Leader

Cable Leader 50ft Cat5e Non-Booted Ethernet Cable Yellow 24AWG 350MHz

SKU CH-FXME-EKMFR

A 50-foot Cat5e patch cable with non-booted RJ45 plugs for high-density installs, tested to 350 MHz for Gigabit Ethernet

  • TypeNetwork Ethernet Cables
  • Cat5E
  • Connector ARJ45
  • Connector BRJ45
  • Length50 ft.
  • ColorYellow
  • Gigabit Ethernet ready with 350 MHz tested performance
  • Non-booted plugs fit dense patch panels and keystone jacks
  • 24 AWG bare copper conductors with gold-plated contacts
  • 50 ft yellow UTP cable for structured cabling runs
  • RoHS compliant with UL and ETL verification

Cable Leader 50ft Cat5e Yellow Ethernet Cable

This 50-foot Cat5e patch cable delivers a reliable Gigabit Ethernet connection for structured cabling. The non-booted RJ45 plugs are designed for high-density patch panels and keystone jacks where space is tight. Four twisted pairs of 24AWG bare copper conductors ensure solid signal integrity. It is a cost-effective choice for data centers, server rooms, and office networks.

Upgrade from slower or booted Cat5e cables

Replace older 100MHz-rated cables with this 350MHz-tested cable to fully support 1000BASE-T speeds. The non-booted design solves the clearance problems caused by bulky molded boots in crowded racks. The jump is worth it when airflow and port density matter more than connector strain relief. It also replaces shielded cable runs where UTP is specified and EMI is not a concern.

Fits dense racks and PoE devices without extra bulk

The slim, non-booted plugs seat cleanly in patch panels, switches, routers, and PoE equipment, freeing up space for adjacent connections. Bare copper conductors and 50-micron gold-plated contacts maintain performance across the run. RoHS compliance and UL & ETL verification meet common project specifications. Builders needing shielded cable or 10-Gigabit bandwidth over 100 meters should look elsewhere.

Highlights

  • Gigabit Ethernet ready with 350 MHz tested performance
  • Non-booted plugs fit dense patch panels and keystone jacks
  • 24 AWG bare copper conductors with gold-plated contacts
  • 50 ft yellow UTP cable for structured cabling runs
  • RoHS compliant with UL and ETL verification

Specifications

TypeNetwork Ethernet Cables
Cat5E
Connector ARJ45
Connector BRJ45
Length50 ft.
ColorYellow
ShieldedNo
Wire Gauge24 AWG

Questions about this item

Will the 50ft non-booted RJ45 plugs fit side-by-side in a high-density 24-port patch panel?

Yes, the non-booted design removes the molded boot so each 8P8C plug seats flush in tightly packed keystone jacks and patch panels, improving airflow and cable management.

Do I need a special crimp tool or punch-down block to install this pre-terminated 50ft Cat5e cable?

No, both ends already have factory-terminated RJ45 connectors with 50-micron gold-plated contacts; just route the 24AWG bare copper cable and snap the plugs into your switch, router or patch panel ports.

When should I replace this 350MHz-tested Cat5e cable in a structured cabling run?

Replace it if the jacket is kinked, the non-booted plug tabs snap off, or you upgrade the link beyond 1000BASE-T speeds that the Cat5e 350MHz rating supports.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.