We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three white SATA cables with 90-degree connectors and locking latches

BUCIER

BUCIER SATA Cable III 3 Pack 90 Degree 6Gbps 50cm White

SKU CH-CBR2-APNYR

Three SATA 3.0 cables with 90-degree locking connectors, 50 cm length, 6 Gbps rated for HDDs and SSDs

  • ColorWhite
  • Transfer 1 GB in about 5 seconds with 6 Gbps SATA 3.0 speed
  • Three cables in one pack give spares for RAID or multiple drives
  • 90-degree connectors fit tight spaces behind drives and motherboards
  • Locking latches on both ends keep connections secure during vibration
  • White 50 cm length suits clean internal cable routing

Three-pack SATA III cables for storage upgrades

This three-pack supplies three SATA III cables with a 90-degree connector on each end, intended for builders adding or replacing hard drives, solid-state drives or optical drives. The white colour helps identify cables inside a case. Each cable carries a locking latch to resist vibration. The pack suits anyone expanding internal storage on a desktop system.

Replaces older SATA I

The cables conform to SATA revision 3.0 and support up to 6 Gbps transfer rates, doubling the ceiling of the previous revision while remaining backwards compatible with SATA I and SATA II devices. The upgrade is worthwhile when the host controller and the drive both support the higher signalling rate; otherwise the link will simply negotiate the lower speed.

Verify connector orientation

Each end uses a straight 90-degree plug, so confirm that the motherboard and drive ports have enough clearance for the right-angle profile. The cables measure 50 cm (18 in), which suits typical mid-tower layouts but may fall short in full-tower or server chassis where routing distances are longer. Ensure the locking latches can engage fully on both devices.

Highlights

  • Transfer 1 GB in about 5 seconds with 6 Gbps SATA 3.0 speed
  • Three cables in one pack give spares for RAID or multiple drives
  • 90-degree connectors fit tight spaces behind drives and motherboards
  • Locking latches on both ends keep connections secure during vibration
  • White 50 cm length suits clean internal cable routing

Specifications

ColorWhite

Questions about this item

What length and connector angle do these SATA cables have?

Each cable is 50 cm (18 inch) long and uses a straight connector on one end with a 90-degree right-angle connector on the other.

How do I secure the locking latch on the SATA 3.0 connectors?

Align the connector with the port, push straight in until the metal latch clicks, and pull gently to confirm it is locked; do not force the cable sideways.

When should I replace these SATA cables?

Replace a cable if the latch no longer clicks, the connector wiggles in the port, or you see intermittent drive detection and data errors.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.