We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black Mini SAS SFF-8087 male to four SATA 7-pin female breakout cable 1.6 ft

BUCIER

BUCIER Mini SAS SFF-8087 to 4 SATA 0.5M 1.6FT 6Gbps 30AWG

SKU CH-C9G3-F06BX

Connects a Mini SAS SFF-8087 controller to four SATA drives at 6Gbps using 30AWG cable

  • TypeMINI SAS CABLE
  • ColorBlack+Blue
  • Length1.6
  • Speed6 gigabits_per_second
  • ConductorCopper
  • FeaturesMINI SAS SFF-8087 to SATA Cable
  • Connect up to four SATA drives via one Mini SAS SFF-8087 port
  • 6 Gbps per lane supports fast data throughput
  • 30 AWG thin cable bends easily in tight chassis
  • 5 m length keeps internal routing short and tidy
  • Locking latches on both ends secure connections against vibration

SFF-8087 to 4 SATA breakout

This 0.5 metre cable links an internal Mini SAS 36-pin SFF-8087 male port on a controller or motherboard to four SATA 7-pin female connectors for drives. It is built for professionals expanding storage with a SAS HBA or RAID card. The forward breakout design carries data from the host side to each target drive at up to 6 Gbps per channel. Buyers who need a cable for a backplane SFF-8087 port cannot use this product.

Locking latches and labelled leads

Both ends feature locking latches that hold the connectors firmly in place during operation. The four SATA tails are individually labelled to simplify cable management when routing to multiple hard drives or SSDs. Thin 30 AWG conductors keep the assembly flexible for tight chassis routing. No additional software, adapters or power leads are included in the package.

Straightforward internal install

Connect the SFF-8087 male end to the controller and press each SATA female end onto a drive or backplane until the latch clicks. The short 1.6 foot length limits slack but reduces signal loss. A common error is plugging the SFF-8087 side into a backplane instead of the host controller, which prevents the link from working. Verify the host port is SFF-8087 before fitting.

Highlights

  • Connect up to four SATA drives via one Mini SAS SFF-8087 port
  • 6 Gbps per lane supports fast data throughput
  • 30 AWG thin cable bends easily in tight chassis
  • 5 m length keeps internal routing short and tidy
  • Locking latches on both ends secure connections against vibration

Specifications

BrandADCAUDX
ModelMINISAS-001
TypeMINI SAS CABLE
ColorBlack+Blue
Length1.6
Speed6 gigabits_per_second
ConductorCopper
FeaturesMINI SAS SFF-8087 to SATA Cable

Questions about this item

Will the 30 AWG conductors need replacement if I route the cable through tight bends?

The 30 AWG copper conductors are thin and flexible for routing, but repeated sharp bends can fatigue any cable; inspect the SFF-8087 latch and SATA connectors periodically for loose pins.

What limits sustained throughput when four drives are active on this breakout?

Each SATA leg is rated at 6 Gbps, so the aggregate ceiling is the SFF-8087 host link; the cable itself does not impose a lower bottleneck.

Does the cable run warm or draw extra power during all-day RAID rebuilds?

Passive copper construction adds no active heat or power draw; only the controller and drives generate warmth, so cable temperature stays near ambient.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.