We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular DVI switch box with two input ports and one output port

BUCIER

BUCIER DVI Switch 2 in 1 Out 4K Port Switcher Selector

SKU CH-H0KF-RRVC5

A DVI switch routes two sources to one display at up to 2560 x 1600 resolution and switches in about two seconds with EDID memory

  • TypeDVI
  • Ports2
  • Input Connector2
  • Weight0.522 kilograms
  • Switch between two DVI sources on one monitor
  • Both inputs and output compatible with HDMI signals
  • Switching completes in about two seconds with EDID memory
  • Supports resolutions up to 2560 x 1600 at 60 Hz
  • Plug-and-play with last-state memory after power loss

DVI 2-in-1 Switch with EDID

The BUCIER switch connects two DVI sources to a single DVI display. Both inputs and the output are HDMI-compatible through passive adapters. Switching occurs in roughly two seconds thanks to stored EDID data on each port. The unit remembers the last active input after a power loss.

Users needing simple source selection

This switch suits anyone who wants to toggle between two computers, a laptop and a DVR, or similar DVI devices on one monitor. It does not support Dual-Link DVI signals, so builders who need 2560 x 1600 resolution must look elsewhere. The 0.522 kg weight makes it easy to place on a desk or rack shelf.

Maximum supported resolution 1600

The specification lists a ceiling of 1600 vertical pixels for DVI signals, explicitly ruling out 2560 x 1600. If your sources and monitor operate at or below that limit the switch will pass the signal without configuration. Higher-resolution workflows require a different solution.

Highlights

  • Switch between two DVI sources on one monitor
  • Both inputs and output compatible with HDMI signals
  • Switching completes in about two seconds with EDID memory
  • Supports resolutions up to 2560 x 1600 at 60 Hz
  • Plug-and-play with last-state memory after power loss

Specifications

BrandBUCIER
Part NumberGuangDa
TypeDVI
Ports2
Input Connector2
Weight0.522 kilograms

Questions about this item

Does the BUCIER DVI switch require external power or rack space to install?

The unit weighs 0.522 kg and operates without an external power supply, so it sits on a desk or shelf and only needs three DVI cables.

What is the correct cable order when connecting two sources and one display to the BUCIER switch?

Plug each source into the two input ports, connect the display to the single output port, then press the front button to select the active source.

Will the BUCIER switch need firmware updates or EDID resets over time?

The switch stores EDID data internally and remembers the last selected input after power loss, so no firmware updates or manual EDID resets are required.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.