Bolton Technical
Bolton Technical Bolton400 50-ohm Black Coaxial RF Cable 500 Ft
Ultra low-loss 50-ohm coaxial cable with 6 dB loss per 100 feet and N-Male connectors for cellular boosters and WiFi repeaters
- Works with any 50 Ohm RF system including cell boosters and WiFi repeaters
- Low 6 dB loss per 100 feet keeps signal strong over long runs
- CL3 rated for up to 300 volts suits commercial installs
- Triple-shielded insulated interior delivers highest signal quality
- 500-foot spool enables extended cable runs without joins
Bolton400 50-Ohm Coaxial RF Cable
The Bolton400 is a 500-foot ultra-low-loss coaxial cable built for 50-ohm RF systems such as cell-phone boosters and Wi-Fi repeaters. It carries dual N-Male connectors and a black jacket rated CL3 for up to 300 volts in commercial installations.
Ideal for long booster runs.
Installers running cable between outdoor antennas and indoor boosters across large buildings gain from the 6 dB loss per 100 feet and triple-shielded construction. Buyers needing only a few feet for equipment racks or tight enclosures should consider a shorter, more flexible assembly instead.
6 dB loss per 100 feet at 50 ohms
This attenuation figure is the key metric that determines whether the 500-foot length will deliver usable signal to your booster without excessive degradation. Match it against your system link budget before committing to the full reel.
Highlights
- Works with any 50 Ohm RF system including cell boosters and WiFi repeaters
- Low 6 dB loss per 100 feet keeps signal strong over long runs
- CL3 rated for up to 300 volts suits commercial installs
- Triple-shielded insulated interior delivers highest signal quality
- 500-foot spool enables extended cable runs without joins
Specifications
No published specifications for this item yet.
Questions about this item
What connectors does the 500 Ft Bolton400 cable have so I can attach it to my booster?
The cable is terminated with N-Male connectors on both ends for direct connection to 50 Ohm booster ports.
Will this CL3-rated 500 Ft run work safely alongside existing 300-volt building wiring?
Yes, the CL3 rating means the cable is approved for up to 300 volts in commercial building installations.
How can I confirm the 500 Ft Bolton400 is performing at its 6 dB per 100 Ft loss spec after installation?
Measure signal strength at the booster output and antenna input; the drop should match roughly 30 dB total for the full length.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00113914BTC
In stock
