BFKK
BFKK NanoVNA-H4 V4.3 10kHz-1.5GHz 4in network antenna
Measures S-parameters, VSWR, phase and delay from 10 kHz to 1.5 GHz with a 4-inch display and 1950 mAh battery
- Measures antenna performance up to 1.5 GHz frequency
- 70 dB dynamic range below 300 MHz for accurate readings
- 4 inch LCD display enables standalone portable operation
- 1950 mAh battery or USB power for field use
- Includes SMA calibration kit and two RG174 cables
NanoVNA-H4 V4.3 Vector Analyzer
The BFKK NanoVNA-H4 V4.3 is a handheld vector network analyzer covering 10 kHz to 1.5 GHz. It targets radio amateurs and RF engineers who need portable S-parameter, VSWR, phase and delay measurements with a built-in 4-inch LCD.
Frequency Performance Limits
Direct si5351 output delivers better than 70 dB dynamic range from 50 kHz to 300 MHz, better than 60 dB from 300 MHz to 900 MHz and better than 40 dB from 900 MHz to 1.5 GHz. Metal shielding reduces external interference to improve measurement accuracy across these bands.
Installation and Common Issues
The package includes the analyzer with 1950 mAh battery, USB Type-C cable, two 30 mm SMA male-to-male RG174 cables, a simple calibration kit and an SMA female-to-female connector. PC control uses NanoVNASaver software for Touchstone export. Note that the SD slot only accepts low-speed SPI-mode cards up to 32 GB.
Highlights
- Measures antenna performance up to 1.5 GHz frequency
- 70 dB dynamic range below 300 MHz for accurate readings
- 4 inch LCD display enables standalone portable operation
- 1950 mAh battery or USB power for field use
- Includes SMA calibration kit and two RG174 cables
Specifications
No published specifications for this item yet.
Questions about this item
Which frequency range and dynamic-range figures should guide my choice of this analyser?
The unit covers 10 kHz to 1.5 GHz; direct si5351 output gives better than 70 dB dynamic range from 50 kHz to 300 MHz, extended bands give better than 60 dB to 900 MHz and better than 40 dB to 1.5 GHz.
What S-parameters can I measure with the default firmware on this VNA?
Default firmware measures S11 and S21 via the TX/RX method; obtaining S12 and S22 requires manually swapping the transceiver port wiring.
What SD-card interface does the 4.3 hardware support and what capacity limit applies?
The added SD port works with low-speed SPI-mode cards only and supports up to 32 GB capacity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
