We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

BFKK

BFKK 24V 2A 48W AC/DC Power Adapter 5.5mm×2.1–2.5mm Plug

SKU CH-JZVT-3R5ZN

Delivers 24 V at up to 2 A with 100–240 V AC input and 5.5 × 2.1–2.5 mm barrel plug

  • Works worldwide with 100-240 V AC input
  • Delivers stable 24 V DC at up to 2 A for reliable device operation
  • Fits 5.5 mm barrel plugs with 2.1–2.5 mm centre pins for broad compatibility
  • Includes screw-terminal DC connector so you can attach wires without soldering
  • Built-in overload, over-voltage, over-temperature and short-circuit cut-offs protect connected equipment

24V 48W AC/DC adapter for low-power DC devices

This 24 volt 2 amp power supply converts 100 to 240 volt AC mains into a stable 24V DC output rated at 48 watts. It suits LED strip lighting, CCTV cameras, DC water pumps and similar 24V equipment drawing up to 2 amps. The barrel connector measures 5.5 mm outer diameter with a 2.1 to 2.5 mm inner diameter. A screw-terminal female plug is included for solderless wiring.

48 watt headroom for loads up to 2 amps

Continuous output is 24V at 2 amps maximum, so any device rated below 48 watts runs with headroom. Example draws such as 500 mA, 1 A, 1.2 A, 1.4 A, 1.5 A, 1.6 A and 1.8 A all operate safely. The unit cannot power 5V, 9V, 12V, 19V, 36V or 42V gear, and it will shut down if the connected load exceeds the 2 amp limit.

Overload, over-voltage.

Automatic cut-off circuits interrupt power during fault conditions, protecting both the adapter and the connected device. The 5.5 mm × 2.1–2.5 mm barrel jack fits common DC sockets, while the supplied female connector accepts bare wires secured by screw terminals. This arrangement allows quick installation without soldering in lighting, surveillance or pump applications.

Highlights

  • Works worldwide with 100-240 V AC input
  • Delivers stable 24 V DC at up to 2 A for reliable device operation
  • Fits 5.5 mm barrel plugs with 2.1–2.5 mm centre pins for broad compatibility
  • Includes screw-terminal DC connector so you can attach wires without soldering
  • Built-in overload, over-voltage, over-temperature and short-circuit cut-offs protect connected equipment

Specifications

No published specifications for this item yet.

Questions about this item

Will the 5.5 mm × 2.1–2.5 mm barrel plug fit the existing jack on my older 24 V LED strip or CCTV camera?

The adapter ships with a 5.5 mm outside / 2.1–2.5 mm inside diameter barrel plug and a matching screw-terminal female connector, so it mates with the common 5.5 × 2.1 mm and 5.5 × 2.5 mm jacks found on most 24 V strips and cameras.

How can I confirm the adapter is delivering a steady 24 V after I wire it up?

Measure the output with a multimeter set to DC volts; you should read 24 V at the barrel plug when the unit is powered and no load or a load under 2 A is connected.

Does the box include the screw-terminal female DC connector, or do I need to buy one separately?

The female DC barrel connector with screw terminals is included in the package; no extra connector purchase is required for wiring bare leads.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.