We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short galvanized steel pipe nipple with threaded ends

Beck C. H.

Beck C. H. 331017004 1/2" MNPT x 7-1/2" TBE Galvanized Steel Pipe Nipple Sch 40

SKU CH-D07P-JMKQR

Galvanized steel pipe nipple with 1/2 inch MNPT and 7-1/2 inch TBE for air, gas, oil and non-potable water at 150 psi

  • ColorTransparent
  • TypePipes, Valves & Fittings
  • 1/2 in NPT threads connect to standard fittings
  • 7-1/2 in length spans the required gap
  • Galvanized steel resists corrosion in air and water lines
  • Schedule 40 wall rated for 150 psi at 150 °F
  • Made in USA from Grade B welded steel

Pipe Nipple for Air, Gas and Oil Lines

This galvanised steel nipple connects 1/2 inch male NPT threads on each end for air, gas, non-potable water or oil systems. The Schedule 40 welded construction suits general-purpose industrial and commercial piping installations. It is manufactured in the USA from Grade B steel with a protective galvanised coating.

150 psi Maximum Operating Pressure at 150 °F

The single figure that decides fit is the 150 psi pressure rating at 150 degrees Fahrenheit. Systems that run hotter or above this pressure need a heavier-wall fitting, while lower-pressure lines can use this nipple safely.

7-1/2 Inch Length with 5/8 Inch Bore

The 7-1/2 inch overall length and 5/8 inch inside diameter give enough reach for tight offsets and adequate flow for typical half-inch service lines. It does not suit potable water, steam service or applications demanding higher pressure or temperature limits.

Highlights

  • 1/2 in NPT threads connect to standard fittings
  • 7-1/2 in length spans the required gap
  • Galvanized steel resists corrosion in air and water lines
  • Schedule 40 wall rated for 150 psi at 150 °F
  • Made in USA from Grade B welded steel

Specifications

BrandBECK
ColorTransparent
TypePipes, Valves & Fittings

Questions about this item

What does the 150 psi rating mean when this nipple is installed in a piping system?

It indicates the maximum operating pressure the nipple can handle at 150 degrees Fahrenheit for air, gases, non-potable water, and oils.

How does the 1/2 inch MNPT thread standard limit what this nipple connects to?

The 1/2 inch Male National Pipe Taper threads require matching female NPT fittings to create a sealed joint.

What clearance is needed to fit the 27/32 inch outside diameter through a wall or bracket?

An opening slightly larger than 27/32 inch is required to accommodate the galvanized steel pipe body.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.