We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black USB-A to Micro USB cable with inline 501 button switch, 1m 3.28ft length

Bazarc

Bazarc USB to Micro USB Cable with Switch 1m 3.28ft 501 button 3A

SKU CH-GJTD-YRS7D

A 1-metre USB-to-Micro-USB power cable with an inline on/off switch rated for 3 A charging

  • TypeOther
  • Built-in switch lets you power cycle without unplugging
  • 3 A rating supports Raspberry Pi, USB peripherals and overclocking
  • 1 m length gives flexible placement on the bench
  • Micro USB connector fits Pi and many other boards
  • Black finish matches typical enclosure colours

USB–Micro USB cable with integrated power switch

The cable carries power from a USB-A source to a Micro USB device and includes a 501 button that lets you cut power without unplugging. It is intended for single-board computers such as the Raspberry Pi and similar low-power boards that use Micro USB for supply.

On-board switch removes the need to pull the plug

The 501 button breaks the supply line so the board can be rebooted or shut down cleanly while the power adapter stays connected. This reduces wear on the Micro USB port and avoids the hassle of hunting for a wall socket each time you cycle power.

Plug both ends and press the button to start

The Micro USB connector fits the board’s power input and the USB-A end fits any 5 V charger or hub. The supplier notes the source should deliver at least 5 V and 700 mA, and that attached peripherals or overclocking increase the draw. The cord is rated for 3 A, so it handles the extra load without a separate inline fuse.

Highlights

  • Built-in switch lets you power cycle without unplugging
  • 3 A rating supports Raspberry Pi, USB peripherals and overclocking
  • 1 m length gives flexible placement on the bench
  • Micro USB connector fits Pi and many other boards
  • Black finish matches typical enclosure colours

Specifications

TypeOther

Questions about this item

Will the on/off switch mechanism on this cable wear out over time?

The cable uses a 501 button switch rated for repeated toggling; no periodic replacement is required under normal use.

What limits how long I can run a Raspberry Pi on this cable without issues?

The 3 A current rating is the ceiling; sustained loads above that will cause voltage drop or shutdown.

Does the cable or its switch get warm when powering a Pi and peripherals all day?

At loads up to 3 A the conductors and switch stay cool; only sustained draws near the limit produce noticeable warmth.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.