Anvil
Anvil 0500093554 Pipe Clamp 1-1/2 In 4-5/16 In L
Secures 1-1/2 inch pipe with a carbon-steel clamp rated for 800 lb at 650 degrees F and listed to UL, FM and ANSI/MSS SP-69 standards
- TypeDrain Components
- Carbon steel construction resists corrosion for long service life
- Supports 800 lb at 650 °F for reliable hot-line suspension
- Meets Federal Spec A-A-1192A Type 4 and ANSI/MSS SP-69 standards
- UL, ULC listed and FM approved for code-compliant installations
- Plain finish with metal-detectable material aids inspection and safety
Carbon Steel Pipe Clamp
The Anvil 0500093554 is a medium carbon steel pipe clamp designed to secure 1-1/2 inch pipes. It measures 4-5/16 inches in length and uses a 5/16 inch thread size. The plain finish clamp is metal detectable and rated for a maximum load of 800 pounds at 650 degrees Fahrenheit.
Suspension For Uninsulated Hot And Cold Lines
This clamp suits installers suspending cold pipe lines or hot lines where no insulation is required. It meets Federal Specification A-A-1192A Type 4, WW-H-171-E Type 4, ANSI/MSS SP-69 and MSS SP-58 Type 4 standards with UL, ULC and FM approvals. It is not for systems requiring insulated pipe support or for pipe sizes other than 1-1/2 inch.
800 Lb Load Rating At 650 Degrees F
The decisive specification is the 800 pound maximum load rating at 650 degrees Fahrenheit. This figure determines whether the clamp can safely support the specific piping system weight and operating temperature. Verify this capacity against the project requirements before purchase.
Highlights
- Carbon steel construction resists corrosion for long service life
- Supports 800 lb at 650 °F for reliable hot-line suspension
- Meets Federal Spec A-A-1192A Type 4 and ANSI/MSS SP-69 standards
- UL, ULC listed and FM approved for code-compliant installations
- Plain finish with metal-detectable material aids inspection and safety
Specifications
| Type | Drain Components |
|---|---|
| Brand | Anvil |
| Model | 0500093554 |
Questions about this item
Will the 5/16 inch thread size on this Anvil 0500093554 clamp match the existing rod on my current pipe supports?
The clamp uses a 5/16 inch thread size, so it will match any hanger rod with the same thread pitch and diameter.
How can I confirm the clamp is properly installed and rated for my 650 degree F hot line?
Verify the carbon steel body and plain finish are intact, then check that the applied load does not exceed 800 lb at the 650 degree F service temperature.
Does the box include the hanger rod and nuts, or do I need to buy them separately?
The package contains only the pipe clamp itself; the 5/16 inch threaded rod, nuts, and any washers must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
K Tool International
K-Tool International SF-7212 Pitman Arm Puller Ball Joint Separator Tie Rod Tool
$78.99
0.00095441BTC
In stock
