We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black malleable iron reducing tee with three female NPT ports

Anvil

Anvil 0310047204 reducing tee trap

SKU CH-PHFG-HZ4G8 MPN 0310047204

A malleable iron reducing tee with three female NPT connections rated for 300 psi at 150 degrees Fahrenheit

  • TypeDrain Components
  • Malleable iron construction resists corrosion in plumbing systems
  • Class 150 rating suits Schedule 40 pipe installations
  • 300 psi at 150 °F handles demanding pressure loads
  • Three female NPT ports enable flexible pipe connections
  • Reducing tee design joins 1-1/2 in and 1 in lines

Product Identity

The Anvil 0310047204 is a Class 150 malleable iron reducing tee with female NPT threads on all three ports. It joins a 1 in branch to a 1 1/2 in run for Schedule 40 piping systems.

Upgrade Context

This fitting replaces a straight tee when a pipe run must step down to a smaller branch line without adding a separate reducer. The change is worthwhile when the design calls for a single compact junction rated for 300 psi at 150 degrees F.

Installation Notes

Thread sealant or tape on the NPT connections provides a reliable seal when tightened to the proper engagement. Over-tightening can crack the iron casting, and mixing thread standards will cause leaks.

Highlights

  • Malleable iron construction resists corrosion in plumbing systems
  • Class 150 rating suits Schedule 40 pipe installations
  • 300 psi at 150 °F handles demanding pressure loads
  • Three female NPT ports enable flexible pipe connections
  • Reducing tee design joins 1-1/2 in and 1 in lines

Specifications

TypeDrain Components
BrandAnvil
Model0310047204

Questions about this item

Will the 1-1/2" and 1" NPT female threads on this reducing tee match Schedule 40 pipe?

Yes, the tee is rated for Pipe Schedule 40 and has 1-1/2", 1", and 1-1/2" female NPT connections.

Do I need thread sealant when installing this malleable iron tee, and how tight should it go?

Apply PTFE tape or pipe dope to the male threads, then tighten two turns past hand-tight; over-tightening can crack the Class 150 iron.

How often should I inspect or replace this Class 150 reducing tee in a 300 psi system?

Inspect annually for corrosion or leaks; replace if threads show damage or the body cracks, as the 300 psi rating at 150 °F depends on intact iron.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.