Innovation First, Inc. 1UCMA-137 1U Cable Management Arm 19" 28.5"-33" computer accessory
- Product Type:Cable…
- Panel Width:19" Rac…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
aibileec
Connects three case fans to one motherboard header with a 10-inch braided cable; only the 4-pin connector reports RPM while 3-pin fans run at full speed
This PWM fan splitter cable connects a single four-pin motherboard header to three case fans. One branch carries a full four-pin connector for RPM monitoring while the other two use three-pin plugs. The ten-inch length keeps routing tidy inside compact builds.
Black braided sleeving protects the wires and makes cable management easier behind the motherboard tray. The splitter draws all fan power from the single header, so the board must supply enough current for the combined load. No extra power connectors or adapters are required.
Builders who want all three fans to spin at the same PWM duty cycle will appreciate the shared signal design. Users needing independent speed curves per fan or RPM feedback from every unit should look at a fan controller with multiple headers instead.
| Brand | aibileec |
|---|---|
| Type | Fan power splitter cable |
| Color | Black |
| Length | 10 inches |
| Cable Length | 10 in. |
| Connector A | 1x TX4 female |
| Connector B | 3x TX3/TX4 male |
| Connector Number | 4 |
| Features | Features This TX4 4-pin multi-fan splitter cable connects to your motherboard and controls three PWM fans. Since only one RPM signal can be read by one motherboard connector, only one 4 TIPS CONNECTOR of the fan splitter cable carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to full 4-pin connector. The other two male connectors are missing the pins of tachometric signal,ensure your fan speed monitor won't bounce all over the place from getting three sense signals.Guarantee motherboard getting an accurate RPM signal. Only o |
The splitter connects three fans to one header, but only the fan on the 4-pin connector reports RPM data to the motherboard for monitoring.
Yes, every connected fan follows the identical PWM signal so they ramp together, though 3-pin fans will ignore the signal and run at full speed.
The 4-pin female end plugs into any standard CPU_Fan or SYS_Fan header on the motherboard.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?