We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Aqua 32.81 ft fiber patch cable with MPO female connectors both ends

AddOn

AddOn ADD-MPOMPO-10M5OM4 network ethernet cable 32.81 ft MPO Female to MPO Female OM4 12 Fiber Aqua

SKU CH-REBQ-R46ZN MPN ADD-MPOMPO-10M5OM4

A 32.81 ft aqua OM4 fiber patch cable with MPO female connectors on both ends, rated for 100G up to 150 m and OFNR riser fire safety

  • TypeDuplex
  • Connector AMPO (Female)
  • Connector BMPO (Female)
  • Length32.81 ft.
  • ColorAqua
  • FeaturesIt is a 12-colored 0.9mm cable utilizing a male (with pins)
  • 81 ft reach links racks across data-centre rows
  • OM4 50/125 µm fibre supports 100 GbE up to 150 m
  • Female-to-female MPO connectors enable direct patch-panel mating
  • OFNR riser jacket meets fire-safety codes for vertical runs
  • 20 oz lightweight cable eases high-density cable management

Data-centre patch cable

This 32.81 ft OM4 multimode fibre patch cable uses MPO female connectors on both ends and carries 12 strands of 50/125 µm fibre in an aqua OFNR riser-rated jacket. It is built for high-density connections between patch panels, switches, routers and media converters in enterprise environments. The crossover wiring aligns transmit and receive fibres for direct equipment links. Lifetime warranty coverage applies.

Riser-rated backbone link

The OFNR jacket allows vertical routing through building risers without additional fire-barrier measures, so the cable can span floors in a single run. Its 12-fibre MPO interface plugs straight into high-density cassettes or transceiver modules, freeing rack space that individual duplex cords would consume. Standard boot connectors keep installation straightforward in crowded panels. No separate power or active gear is required.

Sustained 100G throughput

OM4 fibre supports 100 Gbit/s transmission over distances up to 150 metres, maintaining signal integrity across the full 32.81 ft length under continuous load. The 50/125 µm core/cladding geometry keeps modal dispersion low during extended high-bandwidth sessions. Passive construction means no thermal throttling or firmware limits affect long-duration transfers. Cable weight is approximately 3.20 oz.

Highlights

  • 81 ft reach links racks across data-centre rows
  • OM4 50/125 µm fibre supports 100 GbE up to 150 m
  • Female-to-female MPO connectors enable direct patch-panel mating
  • OFNR riser jacket meets fire-safety codes for vertical runs
  • 20 oz lightweight cable eases high-density cable management

Specifications

BrandAddOn
ModelADD-MPOMPO-10M5OM4
TypeDuplex
Connector AMPO (Female)
Connector BMPO (Female)
Length32.81 ft.
ColorAqua
FeaturesIt is a 12-colored 0.9mm cable utilizing a male (with pins) MPO connector on one end and 12 male 50/125 multi-mode OM3 LC connectors on the other end. This 40Gig breakout cable is used primarily inside plug-and-play cassette modules. Our patch cables are 100% compliant for all of your networking needs. They provide higher speeds and increased bandwidth, compared to conventional twisted-pair copper cable. Each cable is 100% optically tested for insertion loss before you take ownership. Now you have a cost effective solution to your network upgrade needs.
Shipping weight0.18 kg
Package size330 × 279 × 51 mm

Questions about this item

How far can this OM4 cable carry a 100G signal before distance becomes the limiting factor?

The OM4 multimode fiber supports 100G transmission up to 150 meters, so the 32.81 ft length is well within that limit.

Does the OFNR riser jacket or the 12-strand construction create noticeable heat or power draw during continuous operation?

As a passive fiber patch cable it draws no power and generates no heat; the OFNR jacket is for fire safety in vertical runs, not thermal management.

Which transceivers or patch panels must I already have to connect this MPO female-to-female cable?

You need equipment with MPO male (pinned) ports — such as 40G or 100G QSFP transceivers, MPO cassette patch panels, or MPO adapter plates — on both ends.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.