We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green Cat6a patch cable ten feet long with RJ45 plugs on both ends

AddOn

AddOn 10ft Cat6a RJ-45 M/M green copper patch cable

SKU CH-9S11-5B4VQ

Ten-foot Cat6a patch cable with RJ-45 male connectors on both ends for gigabit Ethernet links

  • 10 ft length reaches distant network ports
  • Cat6a specification supports up to 10 Gbps bandwidth
  • Four twisted copper pairs reduce signal interference
  • Green jacket simplifies cable identification in racks
  • Male RJ-45 connectors on both ends plug directly into equipment

10 ft Cat6a copper patch cable

This AddOn cable provides a ten-foot Category 6a copper link with RJ-45 male connectors on both ends. The green jacket makes it easy to identify in a crowded patch panel or rack. It is built for standard Ethernet networking where a short, reliable copper run is required. Condition is new.

Replaces shorter or lower-category runs

Use this cable when an existing Cat5e or Cat6 patch cord is too short or cannot support the bandwidth your equipment now demands. The Cat6a rating handles higher frequencies, so the upgrade is worthwhile when you move to 10 GbE ports or need better alien-crosstalk margins. The ten-foot length suits typical rack-to-rack or switch-to-patch-panel distances.

Suits installers and network techs

This patch cord suits anyone terminating a green-coded Cat6a link up to ten feet. Buyers who need a different length, a different jacket colour, or a shielded construction should look at something else. It is not intended for outdoor burial, plenum spaces, or fibre-based connections.

Highlights

  • 10 ft length reaches distant network ports
  • Cat6a specification supports up to 10 Gbps bandwidth
  • Four twisted copper pairs reduce signal interference
  • Green jacket simplifies cable identification in racks
  • Male RJ-45 connectors on both ends plug directly into equipment

Specifications

BrandAddOn

Questions about this item

What clearance does the RJ-45 connector need to plug into a standard port?

The RJ-45 male connector fits standard Ethernet ports and needs only enough room for the plug body and latch to seat fully.

How do I secure the cable so the latch does not release during routing?

Press each RJ-45 plug until the latch clicks, then route the ten-foot cable without sharp bends that could lever the latch open.

When should I replace this Cat6a patch cable?

Replace it if the green jacket shows cuts, the latch tabs break off, or connectors develop intermittent contact after repeated insertion cycles.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.