ADCAUDX SATA-011 SATA cable 0.5m 4-pack 90-degree right-angle 6Gbps

Four cables for internal storage builds

This pack contains four SATA data cables, each 0.5 m long, with a straight connector on one end and a 90‑degree right‑angle connector on the other. They link motherboards or host controllers to SATA hard drives, SSDs, optical drives or SAS devices. The cables carry data only; power must be supplied separately. They are intended for builders adding multiple drives in tight spaces.

Straight-to-right-angle layout eases routing

Each cable has a locking latch to prevent accidental disconnection and is wrapped in a nylon braid that keeps the four leads tidy. The right‑angle end fits close to drive connectors where straight plugs would hit case walls or other components. Shielding under the braid uses aluminum foil and Mylar to maintain signal integrity. Cables are labelled P1 to P4 to simplify RAID or multi‑drive setups.

6 Gbps rating sustained through shielding

Rated for 6 Gbps transfer, the cables are backward compatible with SATA I and II devices, so actual throughput depends on the connected hardware. The thin 30 AWG conductors and foil‑Mylar shield reduce crosstalk during continuous read or write workloads. The braided sleeve resists abrasion when cables are routed against chassis edges or drive cages over long periods.