We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black square case fan for Raspberry Pi 4 with screw set

AAAwave

AAAwave ODS701 Armor case fan for Raspberry Pi 4, 6000 RPM, 18 dBA, 2-pin, black

SKU CH-5T1N-5W35X

Cools a Raspberry Pi 4 with a 6000 RPM sleeve-bearing fan rated at 18 dBA and 5 m³/h airflow, powered by a 2-pin 3.0-5.8 V connector, and includes mounting screws

  • Perfect fit for Raspberry Pi 4 case
  • Upgraded sleeve bearing delivers strong airflow at 18 dBA
  • 6000 RPM speed actively reduces overheating
  • 2-pin DC 3.0-5.8 V connector with 60 mm lead
  • Includes screw sets for quick installation

Raspberry Pi 4 Case Fan

This 6000 RPM fan is built for the Raspberry Pi 4 case and ships with mounting screws. It runs on a 2-pin connector at 3.0 to 5.8 V and draws 0.1 A. The sleeve bearing keeps noise to 18 dBA while moving 5 m³/h of air.

Makers with a Pi 4 needing active cooling

The short 60 mm lead reaches the Pi 4 header directly, so no extension cables are required. Builders using boards without a 5 V 2-pin header, or cases that lack the matching cut-out, should look at other cooling methods.

2-pin 5 V power requirement

The fan only works from a 5 V 2-pin header supplying 3.0 to 5.8 V at 0.1 A. If your board or case provides a different voltage, pin count, or header spacing, this cooler will not connect or run correctly.

Highlights

  • Perfect fit for Raspberry Pi 4 case
  • Upgraded sleeve bearing delivers strong airflow at 18 dBA
  • 6000 RPM speed actively reduces overheating
  • 2-pin DC 3.0-5.8 V connector with 60 mm lead
  • Includes screw sets for quick installation

Specifications

No published specifications for this item yet.

Questions about this item

How loud is the 6000 RPM fan when it runs continuously?

The fan is rated at 18 dBA ±10%, so it stays quiet even at full speed.

What power source does the 2-pin connector need?

It draws 0.1 A from any 3.0–5.8 V DC header, such as the Pi 4 GPIO 5 V pin.

Will the 3 × 3 × 0.7 cm housing fit inside my existing Pi 4 armour case?

Yes, it is designed to fit that case perfectly and includes the mounting screws.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.