We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 60mm square case fan 25mm thick ball bearing 2-pin

Zyvpee

Zyvpee PSAD16025BM 60x25mm 12V 0.27A ball-bearing case fan

SKU CH-TB3V-VNT3K

60 mm ball-bearing case fan runs on 12 V at 0.27 A with a two-pin connector

  • TypeCase Fan
  • CompatibilityCase
  • Bearing TypeBall
  • Power Connector2 Pin
  • ColorBlack
  • LEDNon-LED
  • Ball bearing for long service life
  • 12 V 0.27 A draws little power
  • 60×60×25 mm fits standard 60 mm mounts
  • Two-pin connector for simple installation
  • Non-LED black frame keeps builds clean

Compact 60 mm ball-bearing fan

The Zyvpee PSAD16025BM is a 60 by 25 millimetre DC case fan designed for tight chassis spaces or targeted component cooling. It runs on 12 volts and draws 0.27 amps through a simple two-pin connector. The black frame and non-LED blades keep the appearance neutral for any build.

Two-pin power and ball-bearing durability

A standard two-pin header supplies power without PWM control, so speed stays constant unless the motherboard or controller varies voltage. Ball bearings resist dust ingress better than sleeve types and maintain consistent rotation over long service intervals. The square 60 millimetre frame fits industry-standard mounting holes for quick installation.

Low current draw and steady airflow

At 0.27 amps the fan adds minimal load to a 12 volt rail, making it suitable for secondary cooling zones or legacy systems with limited headroom. Ball-bearing operation produces a predictable acoustic signature that does not degrade into rattle as quickly as sleeve alternatives. The compact dimensions allow placement near voltage regulators or drive cages where larger fans cannot reach.

Highlights

  • Ball bearing for long service life
  • 12 V 0.27 A draws little power
  • 60×60×25 mm fits standard 60 mm mounts
  • Two-pin connector for simple installation
  • Non-LED black frame keeps builds clean

Specifications

SeriesPSAD16025BM
ModelPSAD16025BM
TypeCase Fan
CompatibilityCase
Bearing TypeBall
Power Connector2 Pin
ColorBlack
LEDNon-LED
FeaturesDC square Cooler
Dimensions60*60*25mm

Questions about this item

What does the 2-pin connector limit on the PSAD16025BM?

The 2-pin connector supplies 12 V at 0.27 A but provides no PWM or speed-signal wire, so the fan runs at full speed unless the motherboard or controller varies the voltage.

Will the 60 mm by 25 mm frame fit my case fan slot?

The fan measures 60 mm square and 25 mm thick, matching standard 60 mm mounting holes; verify your case has the same hole spacing and clearance.

How do I install the PSAD16025BM and what is the common mistake?

Align the four screw holes, insert screws through the case into the fan frame, then plug the 2-pin header onto the motherboard fan connector; the frequent error is reversing the plug polarity, which prevents the fan from spinning.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.