Zyvpee
Zyvpee MMF-06J24SS CP1 60 mm 24 V .15 A 3-pin case fan
A 60 mm case fan with dual ball bearings running on 24 V at 0.15 A through a three-pin connector
- TypeCase Fan
- CompatibilityCase
- Bearing Type2 Ball
- Power Connector3 Pin
- ColorBlack
- LEDNon-LED
- Dual-ball bearing extends service life
- 24 V .15 A draws minimal power
- 60 mm square fits tight chassis
- 3-pin connector enables speed monitoring
- Black non-LED design keeps build clean
60 mm 24 V case fan for tight builds
This 60 mm square frame fits standard mounting holes and runs on a 24 V DC supply drawing 0.15 A. The three-pin connector provides power and tachometer feedback without PWM control. It suits compact enclosures, inverter coolers or industrial chassis where a small footprint is required.
Two-ball bearing sustains steady airflow
Dual ball bearings reduce friction over long periods, keeping rotational speed stable when the fan runs continuously. The design resists the wear that sleeve bearings show under constant load, so acoustic output stays consistent in always-on environments.
Simple three-pin mount with polarity care
The 3-pin header plugs directly into a matching motherboard or controller header; align the keyed connector to avoid reversed polarity. No screws are included, so reuse existing 60 mm hardware. The lack of PWM means speed scales only with voltage, limiting low-speed tuning.
Highlights
- Dual-ball bearing extends service life
- 24 V .15 A draws minimal power
- 60 mm square fits tight chassis
- 3-pin connector enables speed monitoring
- Black non-LED design keeps build clean
Specifications
| Series | MMF-06J24SS CP1 |
|---|---|
| Model | MMF-06J24SS CP1 |
| Type | Case Fan |
| Compatibility | Case |
| Bearing Type | 2 Ball |
| Power Connector | 3 Pin |
| Color | Black |
| LED | Non-LED |
| Features | DC square Cooler |
| Dimensions | 60*60*25mm |
Questions about this item
How loud and hot does the 60 mm 24 V .15 A 3-pin fan run during continuous operation?
The 2-ball bearing design keeps mechanical noise low while the 24 V .15 A draw limits heat output for all-day use.
What power header must my motherboard or controller provide for this 3-pin 24 V fan?
A standard 3-pin 24 V DC header supplying at least .15 A is required for the MMF-06J24SS CP1 to start and run.
Will the 60*60*25 mm frame with 3-pin connector fit the cut-outs on my older chassis?
The 60 mm square footprint and 25 mm thickness match legacy 6 cm mounting holes, and the 3-pin plug connects to vintage 24 V headers.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114981BTC
In stock
