Zyvpee
Zyvpee BA10033B12U 100mm blower 12V 2.4A 3-wire ball bearing
A 100 mm blower fan with dual ball bearings, 12 V 2.4 A draw and a three-wire connector for PWM control
- TypeBlower
- Fan Size100mm
- Bearing Type2 Ball
- Power Connector3 Wires
- ColorBlack
- LEDNon-LED
- 100 mm blower design moves air through tight spaces
- 12 V 2.4 A power draw suits standard DC supplies
- Dual ball bearing reduces friction for longer life
- 3-wire connector enables speed monitoring and control
- Compact 97 × 33 mm frame fits small enclosures
Compact 100mm blower for tight enclosures
The Zyvpee BA10033B12U is a 100mm blower-style fan built for confined spaces such as small form factor cases or specialised equipment housings. Its radial airflow pattern pushes air directly through restricted channels where axial fans would struggle. The 3-wire connector provides tachometer feedback for speed monitoring. It suits builders who need directed cooling in a 97mm by 33mm footprint.
Ball-bearing thermals at 12V 2.4A
Dual ball bearings support continuous 12V operation at 2.4A while keeping acoustic output predictable over long duty cycles. The blower wheel concentrates static pressure so heat moves through dense fin stacks or narrow ducts without recirculation. Power draw stays proportional to the 12V rail with no additional control circuitry required. Non-LED black housing avoids light bleed in dark chassis.
Drops into 97mm square cut-outs
The 97mm by 33mm frame aligns with standard 100mm mounting holes, letting the unit bolt straight into prepared panels or replacement slots. Three-wire PWM headers on most motherboards or fan controllers accept the connector directly. No supplementary power adapters or ducting kits are included. Builders needing PWM speed curves or addressable lighting should look elsewhere.
Highlights
- 100 mm blower design moves air through tight spaces
- 12 V 2.4 A power draw suits standard DC supplies
- Dual ball bearing reduces friction for longer life
- 3-wire connector enables speed monitoring and control
- Compact 97 × 33 mm frame fits small enclosures
Specifications
| Series | BA10033B12U |
|---|---|
| Model | BA10033B12U |
| Type | Blower |
| Fan Size | 100mm |
| Bearing Type | 2 Ball |
| Power Connector | 3 Wires |
| Color | Black |
| LED | Non-LED |
| Features | DC square Cooler |
| Dimensions | 97*33mm |
Questions about this item
How do I connect the 3-wire 12V 2.4A power lead to a standard motherboard header?
Align the three-pin connector with the 12 V header key and press straight down; the third wire carries the tachometer signal so the board can report blower speed.
When should I replace the 2-ball-bearing blower?
Replace it once the bearing noise becomes audible or the RPM reported by the third wire drops noticeably below the original level.
Will the 97 mm × 33 mm frame fit my 100 mm mounting holes?
The 97 mm square frame with 33 mm depth matches standard 100 mm blower cut-outs; verify hole spacing against the unit before securing.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115015BTC
In stock
