Zyvpee
Zyvpee AFC0812DD 5E1H FHS-A8020B-S444 80*20mm 12V .75A 4 Wire Case Fan
An 80 mm case fan with ball bearing, 12 V .75 A draw and four-wire PWM control
- TypeCase Fan
- Bearing TypeBall
- Power Connector4 wires
- ColorBlack
- LEDNon-LED
- FeaturesDC Case Fan
- Ball bearing reduces friction for longer life
- 4-wire PWM connector enables precise speed control
- 12 V .75 A rating delivers strong airflow
- Compact 80 mm by 20 mm frame fits tight builds
- Non-LED black design keeps system aesthetics clean
Compact 80 mm 4-wire case fan
The Zyvpee AFC0812DD 5E1H FHS-A8020B-S444 is a 12 V .75 A DC case fan with a ball bearing and a standard four-wire connector. Its 80*20 mm frame fits tight chassis slots where larger fans cannot go. The non-LED black finish keeps the look neutral for any build.
Replaces noisy or failed 80 mm units
Swap this in when an existing 80 mm fan develops bearing rattle or loses speed control. The four-wire PWM interface restores automatic curve control that two- or three-wire predecessors lack. The jump is worth it if the motherboard header supports PWM and the current fan cannot be regulated.
Straightforward four-pin installation
Align the keyed connector with the motherboard or controller header and press until it clicks. The 20 mm thickness clears most low-profile coolers, but verify clearance against side-panel brackets before mounting. Over-tightening screws can strip the soft plastic frame, so use light torque.
Highlights
- Ball bearing reduces friction for longer life
- 4-wire PWM connector enables precise speed control
- 12 V .75 A rating delivers strong airflow
- Compact 80 mm by 20 mm frame fits tight builds
- Non-LED black design keeps system aesthetics clean
Specifications
| Brand | Zyvpee |
|---|---|
| Series | AFC0812DD 5E1H |
| Model | FHS-A8020B-S444 |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 4 wires |
| Color | Black |
| LED | Non-LED |
| Features | DC Case Fan |
| Dimensions | 80*20mm |
Questions about this item
Will the 80*20mm frame line up with standard 80 mm mounting holes?
Yes, the 80 mm square frame matches the standard 80 mm fan pattern used on most cases and heatsinks.
How do I connect the 4-wire PWM lead to my motherboard header?
Align the keyed 4-pin connector with the CPU or chassis fan header and press straight down until it clicks; reversing the plug bends pins.
When should I plan to replace the ball-bearing fan?
Ball bearings typically run for years; replace the unit if you hear grinding, vibration, or if RPM drops noticeably under load.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114917BTC
In stock
