Zyvpee
Zyvpee AD07012HX207300 OX 70x20mm 12V 0.23A 3-pin case fan
A 70×20 mm 12 V ball-bearing case fan with a 3-pin connector for CPU or projector cooling
- TypeCase Fan
- Bearing TypeBall
- Power Connector3 Pin
- ColorBlack
- LEDNon-LED
- FeaturesCPU Fan
- Ball bearing for long service life
- 70×20 mm frame fits tight 7020 mounts
- 12 V 0.23 A draw keeps power use low
- Three-pin connector plugs straight into motherboard headers
- Non-LED black design suits stealth builds
Compact 70 mm case fan for tight builds
The Zyvpee AD07012HX207300 OX is a 70 by 20 mm case fan that runs on 12 V and draws 0.23 A. Its three‑pin connector fits standard motherboard headers. The ball bearing is rated for long life in continuous operation. It suits small‑form‑factor PCs, HTPCs or projector coolers where space is limited.
Ball bearing keeps noise low at steady speed
The ball bearing reduces friction so the fan runs quietly at its fixed 12 V operating point. With a 0.23 A draw the power load on the header stays minimal. No PWM curve means the speed stays constant, giving predictable airflow and acoustic output. The non‑LED black frame avoids light bleed in dark chassis.
Three‑pin wiring simplifies installation
The bundled three‑wire lead connects directly to a 3‑pin fan header without adapters. No software or lighting controller is included, so setup is purely plug‑and‑play. Buyers who want variable speed control or RGB illumination will need a different model. The bare‑bones package keeps cost and cable clutter down.
Highlights
- Ball bearing for long service life
- 70×20 mm frame fits tight 7020 mounts
- 12 V 0.23 A draw keeps power use low
- Three-pin connector plugs straight into motherboard headers
- Non-LED black design suits stealth builds
Specifications
| Brand | 3ccooler.com |
|---|---|
| Series | AD07012HX207300 |
| Model | AD07012HX207300 |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| Color | Black |
| LED | Non-LED |
| Features | CPU Fan |
| Dimensions | 70*20mm |
Questions about this item
How do I install the 70x20mm fan with its 3-pin connector?
Align the four screw holes on the 70mm frame with the case or heatsink mounts, then press the 3-pin plug onto the motherboard header matching the keyed groove; the step most people miss is routing the wires so the 20mm thickness does not foul adjacent components.
What maintenance will the ball bearing need over time?
The ball bearing is sealed and requires no lubrication; if noise or vibration appears after extended running, the only remedy is to replace the entire 12V 0.23A unit.
At what point does the 12V 0.23A rating become the limiting factor during continuous operation?
The 0.23A current draw is fixed by the motor design, so the first limit under sustained use is the motherboard header's maximum current — if the header cannot supply a steady 0.23A at 12V the fan will stall or run below spec.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114986BTC
In stock
