We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Zoro Select

Zoro Select O-Ring Viton 13 mm 2.5 mm Black PK25

SKU CH-4T1C-ZKSSK

Pack of 25 Viton O-rings with 13 mm inside diameter and 2.5 mm cross-section, rated from -15 to 400 degrees F

  • Viton material withstands -15 to 400 °F extremes
  • 13 mm inner diameter fits standard metric grooves
  • 5 mm cross-section ensures reliable compression sealing
  • Pack of 25 covers multiple maintenance tasks
  • FDA approved and Prop 65 compliant for regulated use

Zoro Select Viton O-Ring 13 mm ID

This pack contains twenty-five black Viton O-rings with a 13 mm inside diameter and 2.5 mm cross-section. They are rated for temperatures from -15 to 400 degrees F and carry FDA approval. The 75A durometer gives a medium-hard feel suitable for demanding sealing tasks. Metric sizing ensures compatibility with standard hardware.

Suits fuel and oil systems needing chemical

These rings handle aggressive fluids and high heat where standard nitrile would fail. They are not X-ray detectable, so they do not suit production lines that mandate X-ray inspection. Buyers who need metal-detectable seals for food-safety compliance should look elsewhere. The dash number is not applicable for Mil-Spec ordering.

75A durometer Viton rated to 400 degrees F

The 75A hardness and 400-degree upper limit decide whether this material survives your media and temperature. Softer or lower-rated compounds will extrude or degrade in the same service. Verify that the 13 mm ID and 2.5 mm width match your groove dimensions before ordering.

Highlights

  • Viton material withstands -15 to 400 °F extremes
  • 13 mm inner diameter fits standard metric grooves
  • 5 mm cross-section ensures reliable compression sealing
  • Pack of 25 covers multiple maintenance tasks
  • FDA approved and Prop 65 compliant for regulated use

Specifications

BrandZORO SELECT

Questions about this item

What groove width do I need in my existing hardware for the 2.5 mm cross-section?

Machine a groove 2.5 mm wide so the round cross-section seats without stretch or pinch.

Will the 75 A durometer feel too stiff beside the softer rubber seals I already use?

Medium-hard 75 A Viton resists extrusion better than softer rubber, so it stays seated under pressure.

How can I confirm the seal is working after installation?

Pressurise the system to its normal operating level; no fluid or gas should escape past the 13 mm inside diameter.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.