Zoro Select
Zoro Select M08250.100.0070 Carriage Bolt Class 4.6 M10-1.50 70 mm PK50
Pack of 50 zinc-plated steel carriage bolts, M10-1.50 thread, 70 mm length, Class 4.6 strength to DIN 603
- TypeScrews & Bolts
- Class 4.6 steel gives 58,000 psi tensile strength
- Square neck locks into wood to stop bolt rotation
- Zinc plated finish resists corrosion in outdoor use
- M10-1.50 metric coarse thread fits standard M10 nuts
- Pack of 50 bolts covers large fastening jobs
Zoro Select M10 Carriage Bolt Class 4.6
This pack contains fifty zinc-plated steel carriage bolts with a 10 mm metric coarse thread and 70 mm length. They conform to DIN 603 and carry a Class 4.6 strength rating of 58,000 psi tensile strength. The square neck under the round head locks into wood or metal to prevent rotation during tightening. Builders and maintenance crews use them for structural timber joints, fencing and general fabrication.
Square neck eases alignment in drilled holes
The 10.58 mm square neck seats itself when the nut is torqued, so the bolt will not spin while you tighten. A clearance hole slightly larger than 10 mm lets the shank pass without binding. If the neck is driven into material that is too hard or too thin, it may not grip and the bolt can rotate. Corrosion resistance comes from the zinc plating; avoid prolonged exposure to salt water or harsh chemicals.
Class 4.6 limits load in critical joints
The 58,000 psi tensile strength suits non-critical structural connections but is below the grade required for primary load-bearing assemblies in many codes. Metric coarse thread M10-1.50 provides standard engagement; fine-thread or higher-grade fasteners are needed where vibration resistance or higher clamp force is specified. The 23.35 to 24.65 mm head diameter distributes load over a wide area, yet the 5.38 mm head height restricts access in tight countersinks.
Highlights
- Class 4.6 steel gives 58,000 psi tensile strength
- Square neck locks into wood to stop bolt rotation
- Zinc plated finish resists corrosion in outdoor use
- M10-1.50 metric coarse thread fits standard M10 nuts
- Pack of 50 bolts covers large fastening jobs
Specifications
| Brand | ZORO SELECT |
|---|---|
| Type | Screws & Bolts |
Questions about this item
How can I confirm the M10-1.50 carriage bolts are Class 4.6 after installation?
Check for the Class 4.6 marking on the round head and verify the square neck seats fully in the mounting hole to prevent rotation under load.
What comes in the PK50 package and what must I source separately?
The box contains 50 zinc-plated steel carriage bolts to DIN 603; matching M10-1.50 nuts and washers are not included and must be purchased separately.
When should I choose the 70 mm length over other available lengths?
Select the 70 mm length when the combined material thickness plus nut height requires approximately 70 mm of thread engagement for a secure joint.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
