Zoro Select
Zoro Select 90 Degree Brass Hose Barb 1/4 in x 1/4 in NPT
Brass 90-degree elbow connects 1/4-inch hose to 1/4-inch NPT male thread
- 90-degree elbow routes hose in tight spaces
- Brass H59 construction resists corrosion and wear
- 1/4 in barb seals securely on matching hose
- 1/4 in male NPT threads into standard ports
- Reusable design allows disassembly and reinstallation
1/4 in Brass 90 Degree Elbow
This brass hose barb connects 1/4 inch hose to a 1/4 inch male NPT thread at a right angle. It suits compressed-air or vacuum lines where space forces a sharp turn. The male-by-male configuration threads directly into a port and accepts push-on hose without a separate adapter. The fitting is new and reusable for repeated assembly.
Brass H59 construction and barb grip
The body uses H59 brass for corrosion resistance in shop air systems. A single barbed end holds 1/4 inch ID hose through friction, while the NPT end seals with thread tape or compound. No knurl is present, so a wrench flats on the hex section is the intended tightening method. The 90 degree bend keeps hose routing tight against walls or bulkheads.
Replaces straight barb or separate elbow
Builders who currently use a straight barb plus a street elbow can consolidate to this one piece, reducing leak paths and profile height. The jump is worth it when clearance is limited or when vibration makes multi-joint assemblies loosen over time. It does not suit applications requiring a swivel nut, a female port or a vacuum-rated seal.
Highlights
- 90-degree elbow routes hose in tight spaces
- Brass H59 construction resists corrosion and wear
- 1/4 in barb seals securely on matching hose
- 1/4 in male NPT threads into standard ports
- Reusable design allows disassembly and reinstallation
Specifications
| Brand | SPEEDAIRE |
|---|
Questions about this item
What thread standard does the 1/4 in NPT end use and what pressure does it seal to?
It uses a 1/4 in NPT taper thread that seals on thread engagement; the fitting itself carries no published pressure rating.
What hose inside diameter and fitting material are required for the barb end?
The barb accepts 1/4 in ID hose and is machined from H59 brass.
How is the 90 degree elbow installed and which step is often missed?
Slide the hose over the barb, secure with a clamp, then thread the NPT end into the port using pipe sealant on the threads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
