Zoeller
Zoeller 131-0001 1/2 HP 115 V 9.4 A Drain Pump System
A 1/2 HP drain pump system with a 5-gallon polypropylene basin moves 72 gallons per minute at 5 feet of head and 45 gallons per minute at 15 feet of head
- TypeDrain Components
- MaterialHAWA
- 1/2 HP motor delivers strong drainage power
- 115 V operation suits standard household circuits
- 4 A draw ensures efficient energy use
- 72 gpm flow at 5 ft head moves water quickly
- 5 gal polypropylene basin handles high-volume discharge
Drain Pump System 1/2 HP 115 V
The Zoeller 131-0001 is a 1/2 HP drain pump system rated for 115 V and 9.4 A. It uses a vertical float switch with an integral electrical connection. The pump body is cast iron and the impeller is engineered plastic. The polypropylene basin holds 5 gal with a 12-1/5 in. diameter and 10 7/8 in. height.
Suits basement or utility sinks needing automatic
Installers handling grey water from sinks or laundry tubs will find the 72 gpm flow at 5 ft. of head adequate. The 1-1/2 in. inlet and outlet match common drain piping. Buyers who need higher head pressure beyond 15 ft. or a larger basin capacity should look at other models.
Basin and pump arrive assembled for direct placement
The unit sits on a level floor and connects to 1-1/2 in. discharge piping and a 2 in. vent. Float travel must remain unobstructed or the pump will not cycle. Debris in the basin can jam the engineered plastic impeller and reduce flow rates.
Highlights
- 1/2 HP motor delivers strong drainage power
- 115 V operation suits standard household circuits
- 4 A draw ensures efficient energy use
- 72 gpm flow at 5 ft head moves water quickly
- 5 gal polypropylene basin handles high-volume discharge
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Brand | Zoeller |
| Model | 131-0001 |
Questions about this item
What electrical supply do I need for the 115 V 9.4 A motor?
A standard 115 V AC circuit rated for at least 9.4 A is required to run the pump.
Can the 1-1/2 in outlet connect to my existing 1-1/2 in drain line?
Yes, the 1-1/2 in outlet matches a 1-1/2 in drain line for a direct connection.
How do I confirm the float switch is cycling correctly after installation?
Pour water until the level reaches the float actuation point; the pump should start, move 72 gpm at 5 ft head, then shut off when the basin empties.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



