We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black 9V battery snaps with red and black wires ending in white 2-pin PH2.0 plugs

ZDRU 9V Battery Snap to 2-Pin PH2.0 Connector Cable 2-Pack

SKU CH-DGVG-XWMCS

Two-pack of 9V battery snap leads terminated with 2.0 PH connectors for quick power hookup to small boards and components

  • I-type 9V clip with 2-pin PH2.0 connector for direct board power
  • PVC housing and brass contacts give reliable electrical connection
  • Red and black leads identify polarity to prevent reverse wiring
  • Two cables in pack provide spare or dual-project use
  • Secure snap fit resists accidental disconnection during operation

9V battery snap to PH2.0 connector

This two-pack provides I-type 9V battery clips terminated with 2-pin PH2.0 connectors. The cables are built from PVC plastic and brass for reliable contact performance. They suit hobbyists and makers who need a quick, secure power link to small circuit boards, motors or LED projects. Red and black leads identify positive and negative poles for correct polarity.

Stable connection under continuous use

The precisely crafted clips grip the battery terminals firmly so the connection does not slip off during extended operation. Brass contacts maintain consistent conductivity while the PVC housing resists wear from repeated insertion. This construction supports steady current delivery to low-power loads without intermittent disconnects.

PH2.0 pitch decides compatibility

The 2.0 mm pitch of the PH2.0 connector is the single specification that determines whether the cable mates with your board or module. Verify that the target device uses a matching 2-pin PH2.0 header before purchase; a different pitch will not connect.

Highlights

  • I-type 9V clip with 2-pin PH2.0 connector for direct board power
  • PVC housing and brass contacts give reliable electrical connection
  • Red and black leads identify polarity to prevent reverse wiring
  • Two cables in pack provide spare or dual-project use
  • Secure snap fit resists accidental disconnection during operation

Specifications

BrandZDRU

Questions about this item

Does the PH2.0 connector draw noticeable power when the 9V battery snap is left connected all day?

The cable itself has no active electronics, so it only passes the current your circuit draws; idle current is essentially zero.

What must I already have to use this 9V battery snap with the 2-pin PH2.0 connector?

You need a 9V battery and a device or board fitted with a matching 2-pin PH2.0 socket.

Will the PH2.0 connector mate reliably with an older 2.0 mm pitch header I already own?

Yes, the connector follows the standard 2.0 mm pitch, so it fits legacy headers of the same spacing.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.