We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black ABS X-axis limit switch assembly with cable for 3D printer

YINGHUA

YINGHUA X-axis Limit Switch Assembly with Cable 3D Printers Accessory

SKU CH-8BVP-YG286

X-axis limit switch assembly with inductive sensor and cable, built for Genius 3D printers

  • Precise X-axis homing with built-in inductive sensor
  • High switching sensitivity from integrated chip for accurate triggering
  • Reliable signal transmission via included cable assembly
  • Durable ABS housing withstands repeated mechanical stress
  • Direct replacement part designed for Genius 3D printers

X-axis Limit Switch for Genius Printers

This inductive sensor assembly replaces the X-axis limit switch on Genius 3D printers. It includes a pre-wired cable for direct connection to the controller board. The unit is intended for maintenance or repair of the printer's homing system.

Thermals Noise and Power Draw

As a low-voltage signal sensor, the switch draws negligible power and produces no measurable heat during operation. It operates silently with no moving fan or active cooling requirement. The solid-state inductive design avoids mechanical click noise associated with traditional lever switches.

Bundled Cable and Housing Benefits

The included cable removes the need for separate wiring or soldering during installation. An integrated chip provides consistent switching sensitivity for accurate homing cycles. The ABS housing protects the internal electronics from dust and incidental contact inside the build chamber.

Highlights

  • Precise X-axis homing with built-in inductive sensor
  • High switching sensitivity from integrated chip for accurate triggering
  • Reliable signal transmission via included cable assembly
  • Durable ABS housing withstands repeated mechanical stress
  • Direct replacement part designed for Genius 3D printers

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the X-axis limit switch assembly and which step is often done incorrectly?

Mount the switch on the X-axis carriage using the existing screw holes, route the cable along the frame to avoid snagging, and connect the three-pin plug to the mainboard X-endstop port; the step most often missed is securing the cable with zip-ties so it cannot catch on the moving gantry.

What maintenance or replacement will the inductive sensor need over time?

The sensor has no moving contacts, so routine maintenance is limited to keeping the sensing face clean from filament dust and checking the cable insulation for wear; replace the unit only if the LED fails to trigger or the cable conductors break.

What is the first limit that appears during continuous printing with this switch?

The 0–1 cm mounting tolerance means the trigger point can shift slightly after repeated thermal cycles, so the first practical limit is the repeatability of the homing position rather than the sensor’s electronic switching speed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.