We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Metal power supply unit for door lock systems, 12V 5A output

YINGHUA

YINGHUA 12V 5A High End Door Lock Power Supply

SKU CH-CPSK-447CQ

Provides stable 12 V DC power for up to two electric locks from 100–260 V AC input with adjustable 0–15 second delay and short-circuit protection

  • TypeChain Guard
  • MaterialMetal
  • FunctionEntrance
  • Stable 12 V output backed by 100–260 V AC input
  • Powers up to two locks with 5 A capacity
  • Adjustable 0–15 s delay suits various entry needs
  • circuit and fuse protection guards connected devices
  • Reduces controller load and simplifies wiring installation

Power Supply for Access Control

This 12V 5A unit powers electric locks, controllers, readers and exit buttons in a single enclosure. It accepts AC input from 100 to 260V, making it suitable for standard mains supplies worldwide. The supply is designed for installations that run one or two locks from the same source. It replaces separate transformers and reduces wiring complexity.

Metal Enclosure with Selectable Outputs

A metal case provides physical protection and helps suppress interference in busy electrical environments. The output terminals offer both normally closed and normally open contacts so the same unit can drive fail-safe or fail-secure locks. An adjustable delay circuit lets you set the lock release time anywhere from 0 to 15 seconds. Automatic short-circuit protection disconnects the output until the fault is cleared.

5 Amp Rating for Dual Lock Installations

The 5A continuous rating is the deciding figure: it allows two locks to operate simultaneously without voltage sag, whereas a 3A supply is only specified for a single lock. If your project uses one lock, a lower-rated unit will work; if it uses two, this 5A model is the stable choice. No other current rating is offered in this series.

Highlights

  • Stable 12 V output backed by 100–260 V AC input
  • Powers up to two locks with 5 A capacity
  • Adjustable 0–15 s delay suits various entry needs
  • circuit and fuse protection guards connected devices
  • Reduces controller load and simplifies wiring installation

Specifications

TypeChain Guard
MaterialMetal
FunctionEntrance

Questions about this item

What AC input range does the 12 V 5 A supply accept?

The unit accepts AC 90–260 V for the 12 V 5 A variant and AC 100–260 V for the 12 V 5 A high-end variant, covering standard mains worldwide.

What mounting provision does the metal enclosure have?

The metal case is designed for wall mounting with screw holes on the rear flange, allowing secure attachment to a solid surface near the door hardware.

How do I set the lock delay and which terminals do I use for a fail-safe lock?

Adjust the delay potentiometer on the PCB for 0–15 seconds, then wire the lock to the NO and COM terminals for fail-safe operation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.