XtremeVision
XtremeVision XT-9004-CC-LEDKIT 9004 4700uF CanBus decoder electronic
A 4700 uF CanBus decoder eliminates LED headlight errors and flicker for 9004 sockets
- Height1.0 in
- Weight5 ounces
- Eliminates error warnings on European and domestic vehicles
- 4700uF capacitor with built-in resistor solves error messages
- Fixes hyper flashing and burnt-out bulb indications
- Anti-flicker canceller stabilises power from xenon headlights
- 9004 fitment installs in minutes with plug-and-play design
9004 CanBus decoder kit
The XtremeVision XT-9004-CC-LEDKIT is a pair of 4700uF CanBus decoder modules designed for vehicles using a 9004 bulb socket. Each module combines a capacitor and resistor to suppress error codes and flicker that can appear after an LED headlight conversion. The kit is sold new and weighs 5 ounces.
Drivers with LED upgrade issues
Suitable for owners of European or domestic vehicles that report bulb-failure warnings, hyper-flashing or no-flash symptoms after fitting LED bulbs in a 9004 housing. Not intended for vehicles that require a pure load resistor instead of a capacitor-resistor network, or for installations where the factory wiring uses a different bulb base.
4700uF capacitor value
The 4700uF capacitance is the single specification that determines whether this decoder can absorb enough energy to cancel the vehicle’s bulb-monitoring pulses. If the vehicle’s monitoring circuit demands a different capacitance or a resistor-only solution, this kit will not resolve the fault.
Highlights
- Eliminates error warnings on European and domestic vehicles
- 4700uF capacitor with built-in resistor solves error messages
- Fixes hyper flashing and burnt-out bulb indications
- Anti-flicker canceller stabilises power from xenon headlights
- 9004 fitment installs in minutes with plug-and-play design
Specifications
| Brand | XtremeVision |
|---|---|
| Model | XT-9004-CC-LEDKIT |
| Height | 1.0 in |
| Weight | 5 ounces |
Questions about this item
How does the 4700uF capacitor stop the dashboard warning after I fit LED headlights?
The capacitor and built-in resistor simulate the electrical load of a halogen bulb, so the vehicle's onboard computer no longer detects a missing or failed lamp and clears the error code.
What does the 9004 designation tell me about the connector on this decoder?
It matches the standard 9004 three-pin base used on many dual-beam headlight housings, allowing a direct plug-in between the factory harness and the LED driver.
Will the 1.0 in height fit behind a tight headlight housing cover?
At one inch tall the unit is low-profile enough for most factory headlight buckets, but measure your available clearance before installation to be certain.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Cameron Sino Battery for Bosch MTS 5200 Vetronix Engine Analyser 2000mAh 14.40Wh
- 310g
$21.99
0.00025772BTC
In stock
