WUQ
WUQ PRO-FR6NEO 6.5" Full-Range Loudspeaker Silver Aluminum Bullet car electronics accessory
A 6.5-inch full-range loudspeaker with neodymium magnet, silver bullet tweeter and 225W RMS power handling
- Typecar
- 450 W max power handles loud transients
- 225 W RMS delivers sustained clean output
- 5 inch full-range covers 200 Hz to 16 kHz
- Neodymium magnet boosts efficiency and reduces weight
- Silver Bullet resonator tweeter extends high-frequency detail
6.5-Inch Neodymium Full-Range Speaker
The WUQ PRO-FR6NEO is a 6.5-inch full-range loudspeaker designed for car audio upgrades. It uses a neodymium magnet and aluminium voice coil to deliver high output with efficient power use. The silver aluminium bullet tweeter extends high-frequency response for clearer detail. A protective grill is included for straightforward door or panel mounting.
4-Ohm Impedance Matching
This speaker presents a 4-ohm nominal impedance to the amplifier. That figure determines whether your amplifier can drive it cleanly without overheating or current limiting. Check your amplifier’s rated output at 4 ohms before purchase. Mismatched impedance will reduce output or trigger protection circuits.
225 Watts RMS Continuous Power
The driver handles 225 watts RMS continuously and peaks at 450 watts. It reproduces frequencies from 200 Hz to 16 kHz, covering midrange and treble but not sub-bass. For full-range music a separate subwoofer is required. Buyers needing deep bass below 200 Hz should plan an additional low-frequency driver.
Highlights
- 450 W max power handles loud transients
- 225 W RMS delivers sustained clean output
- 5 inch full-range covers 200 Hz to 16 kHz
- Neodymium magnet boosts efficiency and reduces weight
- Silver Bullet resonator tweeter extends high-frequency detail
Specifications
| Type | car |
|---|
Questions about this item
What does the 225 W RMS rating mean once the speaker is installed in a door?
It means the speaker can handle 225 watts of continuous power without thermal damage, so a matching amplifier can drive it at high volume for long periods.
How does the 4‑ohm impedance affect what amplifier I can use?
A 4‑ohm load lets most car amplifiers deliver their rated power cleanly; just match the amp’s RMS output per channel to the speaker’s 225 W rating.
What mounting depth and cut‑out diameter does the 6.5" frame need?
The 6.5 inch frame fits a standard 6.5 inch cut‑out; the included grill covers the mounting hardware for a clean finish.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PAC APH-TY02 Speaker Connection Harness Toyota Lexus 18
- Car Stereo Add-Ons
The Wires Zone Platinum 1/0 AWG Ring Terminals Pair
- Connector and Termi…



