We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular glass touchscreen digitizer for Teclast M40 tablet, 2.5D curved edges, no frame

WMtec

WMtec Teclast M40 TLA007 2.5D LCD Touch Screen Digitizer Assembly Without Frame

SKU CH-0EVW-MMT1W

Replacement LCD touch-screen digitizer assembly for the Teclast M40 TLA007 tablet, supplied without a frame

  • 5D curved glass delivers smooth touch response
  • Designed for Teclast M40 TLA007 tablet model
  • LCD and digitizer combined for straightforward replacement
  • Frameless design allows reuse of original housing

Teclast M40 TLA007 2.5D Digitizer Assembly

This replacement part combines the LCD panel and touch digitizer for the Teclast M40 TLA007 tablet. It arrives as a complete assembly without the surrounding frame, simplifying the repair process for a damaged display. The 2.5D curved glass surface matches the original screen profile.

Passive cooling and low power draw

The screen assembly operates without any active cooling components, so it adds no fan noise to the device. Power consumption is limited to the display and touch controller, drawing minimal current from the tablet battery during normal use. Heat output remains negligible under standard brightness settings.

Highlights

  • 5D curved glass delivers smooth touch response
  • Designed for Teclast M40 TLA007 tablet model
  • LCD and digitizer combined for straightforward replacement
  • Frameless design allows reuse of original housing

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 2.5D digitizer assembly without a frame on the Teclast M40 TLA007, and which step causes the most trouble?

You must bond the 2.5D panel directly to the tablet chassis using adhesive; the step most people get wrong is aligning the 7 inch display and digitizer cables before the glue sets, which can leave the touch layer offset.

What maintenance or replacement will the Teclast M40 TLA007 digitizer assembly need later?

The 2.5D LCD and touch panel are fused; if the glass cracks or touch accuracy drifts, the whole 40 pin assembly must be swapped — there is no separate protector or calibration service.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.