We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Redundant server power supply unit with metal casing and rear connector

WMtec

WMtec 570W Redundant Server Power Supply C570A-S0 RXCPH FU100 VPR1M For R710 T610

SKU CH-DC08-JWZNR

A 570 W redundant server supply compatible with PowerEdge R710 and T610 systems, accepting 100-240 V input at 50-60 Hz

  • 570 W redundant output keeps PowerEdge R710 and T610 servers running during a module failure
  • 100-240 V auto-ranging input accepts global mains voltages from 100 V to 240 V
  • 50-60 Hz frequency tolerance matches standard grid supplies worldwide
  • Hot-swap redundant design allows replacement without shutting down the server
  • Multiple part numbers RXCPH, FU100 and VPR1M confirm exact fit for listed models

Redundant 570W Server PSU

This 570 watt redundant power supply is built for Dell PowerEdge R710 and T610 servers. It suits administrators who need a direct replacement unit that matches the original form factor and part numbers RXCPH, FU100 and VPR1M. The unit is new and ready for immediate installation.

Hot-plug fit for R710 and T610

The supply slides into the server's native redundant bay and connects without adapters or cable changes. Its hot-plug design lets technicians swap a failed module while the system stays online, freeing the second bay for a matching unit to maintain full redundancy.

570 watt capacity with 100-240V input

At 570 watts maximum the module handles the server's rated load with headroom for typical peripheral configurations. The wide 100-240 volt, 50-60 Hz input range accepts standard mains worldwide, drawing up to 7.5 amps at the low end and 3.0 amps at the high end. It does not support non-redundant single-PSU configurations or servers outside the R710 and T610 lines.

Highlights

  • 570 W redundant output keeps PowerEdge R710 and T610 servers running during a module failure
  • 100-240 V auto-ranging input accepts global mains voltages from 100 V to 240 V
  • 50-60 Hz frequency tolerance matches standard grid supplies worldwide
  • Hot-swap redundant design allows replacement without shutting down the server
  • Multiple part numbers RXCPH, FU100 and VPR1M confirm exact fit for listed models

Specifications

No published specifications for this item yet.

Questions about this item

What is the maximum continuous power output of the C570A-S0 unit?

The C570A-S0 delivers up to 570W maximum power for PowerEdge R710 and T610 servers

What input voltage and current range does the power supply accept for continuous operation?

It accepts 100-240V AC at 50-60Hz, drawing 7.5-3.0A depending on input voltage

Which Dell PowerEdge server models are required for this redundant supply to install and operate?

This unit is compatible only with PowerEdge R710 and T610 chassis using part numbers RXCPH, FU100 or VPR1M

New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.