We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver grille 6.5 inch coaxial speaker with translucent tweeter cup showing RGB LED glow

Wet Sounds

Wet Sounds XS-65i RGB 6.5" Car Speaker Silver Grille

SKU CH-176A-ZYHMR

A 6.5 inch coaxial car speaker with integrated RGB LED lighting, 60 watts RMS power handling and a silver grille

  • TypeSpeaker
  • Speaker Size6.5"
  • Integrated RGB LED in tweeter cup for customisable lighting
  • 60 W RMS power handling delivers strong output
  • 40 Hz – 20 kHz frequency response covers full range
  • 6 in mounting depth fits tight door panels
  • 0 in cut-out simplifies installation

Wet Sounds XS-65i RGB 6.5" Coaxial Speaker

The Wet Sounds XS-65i RGB is a 6.5 inch component-style coaxial speaker featuring an integrated RGB LED within the tweeter protection cup. It uses a silver injection-moulded composite cone with a proprietary rubber spider and surround. A ¾ inch aluminium tweeter with a horn flare and rubber magnet boot completes the driver assembly.

Suits owners wanting coloured accent lighting

This speaker suits buyers who want selectable red, blue or green illumination from a 12 volt supply, or full colour mixing via an external RGB controller and RF remote. It is not for buyers who need a separate component set with remote crossovers, or those requiring a speaker without any integrated lighting feature.

Fits a 5.0 inch cut-out with 2.6 inch mounting depth

Installation requires a 5.0 inch hole cut-out and 2.6 inches of clearance behind the mounting surface. The 4 ohm impedance and 60 watts RMS power handling match typical marine or car amplifiers. The Nylas frame and silver grille sit flush once mounted, leaving the tweeter cup visible for the RGB effect.

Highlights

  • Integrated RGB LED in tweeter cup for customisable lighting
  • 60 W RMS power handling delivers strong output
  • 40 Hz – 20 kHz frequency response covers full range
  • 6 in mounting depth fits tight door panels
  • 0 in cut-out simplifies installation

Specifications

TypeSpeaker
Speaker Size6.5"

Questions about this item

What power source and controller do I need to run the RGB LED in the tweeter cup?

The LED connects to 12 volts for a single colour — red, blue or green — or to the Wet Sounds RGB LED controller for unlimited colours, flash and fade via the RF remote.

Will the 4-ohm impedance and 89 dB sensitivity match my factory head unit without an extra amplifier?

At 4 ohms and 89 dB sensitivity the speakers draw moderate current; a factory head unit can drive them, but 60 watts RMS each is best realised with an external amplifier.

How can I verify the speakers are performing correctly once installed?

Play a 40 Hz to 20 kHz sweep and confirm clean output across the range; each speaker should handle 60 watts RMS continuously without distortion.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.