Westward
Westward 53YT11 3/8" Drive 7/8" SAE Socket 12-Point
A 3/8" drive alloy-steel socket with a 12-point opening for SAE fasteners, meeting ASME B107.110-2012 standards
- Typesocket
- Alloy steel construction for lasting strength
- 12-point opening grips multiple fastener angles
- 3/8 inch drive fits common ratchet handles
- Meets ASME B107.110-2012 dimensional standard
- Full polished finish resists corrosion and cleans easily
Professional 12-point socket
The Westward 53YT11 is a 3/8" drive SAE socket sized at 7/8" with a 12-point configuration. It is built from alloy steel and finished with a full polish for corrosion resistance. Mechanics and technicians working on standard fasteners will find it fits typical ratchets and extensions. The overall length is 1 In. and it meets ASME B107.110-2012 standards.
Replaces worn or missing standard sockets
This socket upgrades a toolkit when an existing 7/8" socket shows rounded points, damaged finish or excessive play on the fastener. The jump is worth it when the current tool slips under torque or when a 12-point profile is needed for tighter engagement angles. It is a standard depth accessory, so it suits common clearance situations without requiring deep-well reach.
Handles common 7/8" SAE fasteners
The 12-point geometry provides multiple engagement positions on standard hex heads, offering headroom for restricted swing arcs. It runs out when the fastener is recessed beyond standard depth or when the application demands an impact-rated socket instead of a hand-tool grade alloy steel piece. Tethering requires a separate accessory. California Proposition 65 warnings apply.
Highlights
- Alloy steel construction for lasting strength
- 12-point opening grips multiple fastener angles
- 3/8 inch drive fits common ratchet handles
- Meets ASME B107.110-2012 dimensional standard
- Full polished finish resists corrosion and cleans easily
Specifications
| Brand | WESTWARD |
|---|---|
| Type | socket |
Questions about this item
What drive size does the 3/8" drive 7/8" SAE socket require?
It fits a 3/8 inch female square drive on your ratchet or breaker bar.
How do you install the 12-point 7/8" socket, and what step is often missed?
Slide it onto the 3/8" drive until the detent ball seats; the missed step is confirming the ball clicks into the socket's retention groove.
When should the alloy-steel 12-point socket be replaced?
Replace it if the 12-point opening rounds, the finish cracks, or the drive square shows visible wear that affects engagement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
