Westward
Westward 3CYU8 Tubing Bender 3/8 in Electrician Tool
Bends 3/8 in aluminium, copper, brass and stainless tubing up to 180 degrees with calibrated 15-degree markings and swivel handles
- Bends aluminium, copper, brass and thin-wall steel up to 180°
- Calibrated markings every 15° for repeatable angle accuracy
- 15/16 in centre-line radius suits 3/8 in tubing
- Swivel handles reduce wrist strain during repeated bends
- Manual mechanism needs no power source for on-site work
3/8 Inch Tubing Bender
The Westward 3CYU8 is a manual tube bender designed for electricians and tradespeople who need accurate bends in small-diameter tubing. It handles round aluminium, copper, brass, stainless steel and thin-wall steel with a 3/8 inch outside diameter.
15/16 Inch Centerline Radius
Calibrated angle markings from 0 to 180 degrees in 15-degree increments give clear visual feedback throughout the bend range. The fixed 15/16 inch centerline radius determines the minimum bend curvature, so tighter radii require a different tool.
Manual Swivel Handle Operation
Swivel handles reduce wrist strain during repetitive bending but rely entirely on operator force. The tool cannot bend tubing larger than 3/8 inch outside diameter, nor can it produce radii smaller than the built-in 15/16 inch centerline.
Highlights
- Bends aluminium, copper, brass and thin-wall steel up to 180°
- Calibrated markings every 15° for repeatable angle accuracy
- 15/16 in centre-line radius suits 3/8 in tubing
- Swivel handles reduce wrist strain during repeated bends
- Manual mechanism needs no power source for on-site work
Specifications
| Brand | Westward |
|---|---|
| Model | 3CYU8 |
Questions about this item
Will the 3/8 in calibrated markings on this Westward 3CYU8 still line up with my older 15/16 in radius copper tubing?
Yes, the bender is calibrated from 0 to 180 degrees in 15 degree increments and its centerline bend radius is 15/16 in, matching the tubing you already use.
How can I verify the bender is forming accurate angles after I set it up?
Make a test bend on a scrap piece of 3/8 in copper or aluminum, then measure the angle against the 0 to 180 degree calibrated markings in 15 degree steps.
Does the box include any tubing or lubricant, or just the bender with its swivel handles?
Only the manual tubing bender with swivel handles is supplied; compatible 3/8 in round tubing and any bending lubricant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
