Westward
Westward 30RZ30 Grease Gun Hose 30 in 6000 psi
A 30-inch high-pressure grease hose rated to 6000 psi with spring guards at both ends to prevent kinking
- 30 inch reach extends lubrication access
- 6000 psi working pressure handles demanding grease applications
- 10000 psi maximum pressure rating provides safety margin
- 28000 psi minimum burst pressure ensures hose durability
- 18-8 stainless steel construction resists corrosion
- Spring guards on both ends prevent hose kinking
30 in High Pressure Grease Hose
This 30 inch replacement hose connects to grease guns using 1/8 MNPT fittings on both ends. It is built for professional maintenance and industrial lubrication tasks where reliable high pressure delivery is required.
18-8 Stainless Steel With Spring Guards
The hose is constructed from 18-8 stainless steel and includes a spring guard on each end to prevent kinking during daily use. This design protects the connection points and supports consistent flow in tight or awkward working positions.
6000 psi Working Pressure Rating
The hose handles a working pressure of 6000 psi with a minimum burst pressure of 28000 psi. Buyers needing a hose rated for lower pressures or different thread sizes should verify compatibility before purchasing.
Highlights
- 30 inch reach extends lubrication access
- 6000 psi working pressure handles demanding grease applications
- 10000 psi maximum pressure rating provides safety margin
- 28000 psi minimum burst pressure ensures hose durability
- 18-8 stainless steel construction resists corrosion
- Spring guards on both ends prevent hose kinking
Specifications
| Brand | WESTWARD |
|---|
Questions about this item
What pressure rating does the 1/8 MNPT connection handle in practice?
The hose is rated for a working pressure of 6000 psi with a minimum burst pressure of 28000 psi, so the 1/8 MNPT fittings are designed to hold that same 6000 psi service limit.
What clearance does the 30 in hose with spring guards need to mount without kinking?
The 30 inch length includes a spring guard on each end, so allow at least the full 30 inches plus a small radius at each fitting to keep the guards from binding against adjacent surfaces.
How do I install the hose on my grease gun, and what step is often missed?
Thread the 1/8 MNPT ends into the gun and coupler by hand, then tighten with a wrench; the step many skip is checking that both spring guards sit straight so the hose cannot kink under 6000 psi pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
