Westward
Westward 2AJD2 Center Punch 1/2 In Hex 5 5/16 In L hand tool
A hex-shank center punch with a 3/8-inch flat tip for marking metal surfaces
- TypeHand Held Punches
- Hex shank prevents rolling on metal surfaces
- 5-5/16 in length gives controlled striking leverage
- Flat 3/8 in tip marks hole centers precisely
- Plain grip transfers full hammer force directly
- SAE dimensions fit standard workshop tooling
3/8 Inch Flat-Tip Center Punch
This Westward center punch creates precise starting marks on metal surfaces. The 3/8 inch flat tip concentrates impact force for accurate hole alignment. Its 1/2 inch hex shank prevents rolling and fits standard holders. The tool is intended for mechanics and metalworkers who need repeatable marking.
Plain Grip and No Striking Cap
The plain grip surface offers direct tactile feedback during positioning. No striking cap is included, so the user must supply a suitable hammer or mallet. The automatic mechanism is absent, meaning each mark requires a deliberate manual blow. This design suits operators who prefer full control over impact timing.
Six-Inch Hex Shank for Bench Use
The six-inch overall length provides reach into confined work areas. A two-inch taper guides the tip to the workpiece centre. Hexagon shank geometry resists rotation under off-centre strikes. No tether point or handguard is fitted, so the tool is best suited to bench applications rather than overhead or tethered environments.
Highlights
- Hex shank prevents rolling on metal surfaces
- 5-5/16 in length gives controlled striking leverage
- Flat 3/8 in tip marks hole centers precisely
- Plain grip transfers full hammer force directly
- SAE dimensions fit standard workshop tooling
Specifications
| Brand | Westward |
|---|---|
| Model | 2AJD2 |
| Type | Hand Held Punches |
Questions about this item
Will the 3/8-inch tip on this center punch need replacement after repeated use on metal?
The tip is integral to the hardened steel body, so it does not wear out separately; re-sharpen the existing point when it dulls rather than swapping a replaceable tip.
What stops me from driving the 5 5/16-inch punch deeper during sustained marking work?
The fixed 2-inch taper length and 1/2-inch hex shank limit how far the tool can penetrate before the shank contacts the workpiece.
Does the plain grip on the 1/2-inch hex shank get hot or slip during all-day use?
The plain steel grip transmits impact vibration and can become warm with continuous striking; gloves improve control and reduce heat transfer.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
