Westward
Westward 22XP38 75 ft Corded Drain Cleaning Machine 120V
Clears 3 in to 4 in drain and heating lines with a 75 ft, 1/2 in cable at 716 RPM from a 3/8 hp, 120 V motor weighing 93 lb
- Clears 3–4 in drain lines with 75 ft cable
- 3/8 hp motor spins at 716 RPM for tough blockages
- Includes bulb auger plus three cutters for varied obstructions
- 120 V corded power runs from standard outlet
- 93 lb frame stays stable during heavy-duty cleaning
Westward 22XP38 Drain Machine
The Westward 22XP38 is a corded drain cleaning machine built for professional plumbers and maintenance crews clearing blockages in three-inch to four-inch lines. It runs on 120 V AC and delivers 3/8 hp at 716 RPM through a single 75 ft, half-inch cable. The 93 lb unit includes one bulb auger and three cutters for common drain and heating line obstructions.
Installation and Common Issues
Roll the machine to the clean-out, feed the cable into the line, and engage the motor with the foot switch; the single-speed motor requires no gear changes. The most frequent problem is cable kinking when the cutter hits a solid obstruction, so advance slowly and reverse at the first sign of binding. Lubricate the cable after each job to prevent rust and premature fatigue.
Pre-Order Checks
Confirm the building has a grounded 120 V outlet within reach of the machine’s power cord. Verify the drain lines you service fall between the three-inch minimum and four-inch maximum inside diameter. Ensure you have space to manoeuvre the 93 lb frame through doorways and around fixtures. Check local codes for any licensing or permit requirements before operating powered drain equipment.
Highlights
- Clears 3–4 in drain lines with 75 ft cable
- 3/8 hp motor spins at 716 RPM for tough blockages
- Includes bulb auger plus three cutters for varied obstructions
- 120 V corded power runs from standard outlet
- 93 lb frame stays stable during heavy-duty cleaning
Specifications
| Brand | WESTWARD |
|---|
Questions about this item
How can I verify the machine is running at the rated 716 RPM after setup?
Listen for smooth motor operation and confirm the cable rotates steadily without stalling when engaged in a 3 to 4 inch drain line.
What cables, augers and cutters come in the box and what must be purchased separately?
The package includes one 75 ft, 1/2 in. diameter cable, one bulb auger and three cutters — C cutter, grease cutter and an additional cutter — so no extra cables or tooling are required for standard drain and heating lines.
Which version of the 22XP38 should I choose for 3 to 4 inch drain lines?
The single 120V, 3/8 hp model with 75 ft cable is built for 3 to 4 inch inside diameter drain and heating lines; no other capacity or voltage variants are offered for this machine.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



