Westward
Westward 19ZC69 13mm Open End Torque Wrench Head tool storage
A 13 mm open-end torque-wrench head with 9 mm × 12 mm drive and 99 ft-lb capacity for interchangeable tool storage
- Open-end design gives direct access to 13 mm fasteners
- 9 mm x 12 mm drive fits standard torque wrenches
- Alloy steel construction handles up to 99 ft-lb
- Satin finish resists corrosion during daily use
- Compact 1 5/8 in length works in tight spaces
13 mm Open-End Torque Wrench Head
The Westward 19ZC69 is an interchangeable open-end head sized at 13 mm for use with compatible torque wrenches. It accepts a 9 mm by 12 mm drive connection and is built from alloy steel with a satin finish. This tool suits technicians who need a precise, replaceable head for specific fastener sizes.
9 mm by 12 mm Drive Installation
The head slides onto a 9 mm by 12 mm drive rectangle and locks without extra hardware. Misalignment during fitting can prevent the latch from engaging fully, so the drive faces must be square before pressing home. No calibration shift occurs when the head is swapped correctly.
99 ft-lb Maximum Torque Under Load
Rated to 99 ft-lb, the head maintains its geometry through repeated tightening cycles at the upper limit. Alloy steel construction resists permanent deformation when sustained force is applied, unlike brief peak loads that stay within elastic range. The open-end profile allows access where a ring head cannot reach.
Highlights
- Open-end design gives direct access to 13 mm fasteners
- 9 mm x 12 mm drive fits standard torque wrenches
- Alloy steel construction handles up to 99 ft-lb
- Satin finish resists corrosion during daily use
- Compact 1 5/8 in length works in tight spaces
Specifications
| Brand | WESTWARD |
|---|
Questions about this item
How can I confirm the 13 mm open-end head is calibrated correctly after fitting it to the 9 mm x 12 mm drive?
Apply a known 99 ft-lb reference load; the head should click or deflect exactly at that value, confirming the alloy-steel mechanism is functioning within its rated maximum torque.
What components are included with the 19ZC69 head and what must I supply myself?
The box contains the 13 mm open-end interchangeable head only; you must provide a compatible 9 mm x 12 mm drive torque wrench body to use it.
When should I choose the 13 mm version instead of another size in the Westward 19ZC series?
Select the 13 mm head when the fastener you are tightening requires a 13 mm open-end fit; each model number in the series corresponds to a single specific jaw size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
