Westward
Westward 16Y579 flush trim router bit, carbide tipped, 1/2 in cutter
Carbide-tipped flush trim router bit with a 1/2 in cutter for clean, precise edge trimming
- TypeRouters
- Carbide-tipped edge resists wear for longer cutting life
- 1/2 in cutter diameter handles standard flush-trim tasks
- 1 in cutting length reaches deeper profiles
- 3 3/32 in overall length fits common router collets
Flush Trim Router Bit for Clean Edges
The Westward 16Y579 is a carbide tipped flush trim router bit with a 1/2 in cutter diameter. It is built for woodworkers who need to duplicate a pattern or trim laminate flush to a substrate. The carbide tips resist wear during extended use on abrasive materials. This bit suits both handheld and table mounted routers.
Simple Chuck Install With Bearing Guide
Installation requires a 1/2 in collet; the shank seats directly without adapters. The ball bearing pilot follows the template edge so the cutter does not gouge the workpiece. A common issue is dust buildup on the bearing causing it to drag and burn the profile. Regular cleaning and light lubrication keep the bearing spinning freely.
Highlights
- Carbide-tipped edge resists wear for longer cutting life
- 1/2 in cutter diameter handles standard flush-trim tasks
- 1 in cutting length reaches deeper profiles
- 3 3/32 in overall length fits common router collets
Specifications
| Type | Routers |
|---|---|
| Brand | Westward |
| Model | 16Y579 |
Questions about this item
How can I confirm the 1/2 in cutter is trimming flush after setup?
Run the bit along a straight edge; the carbide-tipped cutter should leave a smooth, even surface with no step or ridge between the workpiece and the template.
What comes in the box and do I need a separate shank?
The box contains the flush-trim router bit with its 1/2 in cutter; no additional shank or collet is required as the bit mounts directly in a 1/2 in router collet.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
