We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Westward 16Y577 solid carbide router bit 1/4 inch cutter diameter spiral upcut

Westward

Westward 16Y577 1/4 in Solid Carbide Router Bit

SKU CH-B0E7-C23K6 MPN 16Y577

Solid carbide router bit with 1/4 in cutter diameter for laminated wood, MDF, plywood and wood using a spiral upcut design

  • TypeRouters
  • Weight0.05
  • Solid carbide construction resists wear for longer life
  • 1/4 in cutter diameter suits detailed routing tasks
  • Spiral upcut design clears chips efficiently in wood
  • Lightweight 0.05 lb bit reduces tool strain

Solid Carbide Router Bit

The Westward 16Y577 is a straight router bit made from solid carbide for durability. It features a 1/4 in cutter diameter and a spiral upcut design to clear chips efficiently. The bit weighs 0.05 lb and is suited for use with laminates, MDF, plywood and wood.

Who this suits and who it does not

This bit suits woodworkers and fabricators who need a solid-carbide upcut tool for 1/4 in straight routing in sheet goods and solid wood. Buyers who need a different cutter diameter, a downcut or compression geometry, a bearing-guided profile or a shank size other than 1/4 in should look at other options.

Highlights

  • Solid carbide construction resists wear for longer life
  • 1/4 in cutter diameter suits detailed routing tasks
  • Spiral upcut design clears chips efficiently in wood
  • Lightweight 0.05 lb bit reduces tool strain

Specifications

TypeRouters
Weight0.05
BrandWestward
Model16Y577

Questions about this item

How do I install the 1/4 in solid carbide router bit in my router collet without damaging the shank?

Insert the shank fully into the collet until it bottoms out, then back it out about one millimetre before tightening. Over-tightening with the shank flush against the bottom can crack the solid carbide.

When should I replace the bit, and what wear signs appear on solid carbide when cutting laminated wood or MDF?

Replace the bit when the upcut flutes show rounded edges, burn marks appear on plywood, or feed resistance increases noticeably. Solid carbide holds an edge longer than brazed tips but cannot be resharpened economically.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.