Wera Tools
Wera Tools 05074700001 Torque Screwdriver 1/4 in 0.3 to 1.2 Nm
A click-type torque screwdriver with a 1/4 in drive and 0.3 to 1.2 Nm range includes a calibration certificate
- Precise torque control from 0.3 to 1.2 Nm
- Click-type mechanism signals when target torque is reached
- 1/4 in drive accepts replaceable bits for versatility
- Calibration certificate included for documented accuracy
- Clockwise operation suits standard fastening tasks
Precise Torque Control
The Wera 05074700001 is a click-type torque screwdriver with a 1/4 inch drive and an adjustable range of 0.3 to 1.2 Nm. It includes a calibration certificate and accepts replaceable bits for versatile fastening tasks. The tool delivers audible and tactile feedback when the set torque is reached. It is designed for applications requiring accurate low-torque tightening.
Assembly and Maintenance Use
This screwdriver suits technicians assembling electronics, small mechanisms or precision fixtures where over-tightening risks damage. The clockwise-only operation and 0.05 Nm scale resolution support repeatable results. Buyers needing counter-clockwise torque or higher maximum values should look at other tools. The handle-only design requires separate bit selection for each job.
Calibration Certificate Included
A factory calibration certificate ships with every unit, confirming accuracy out of the box. This documentation is essential for quality-controlled workflows and audit trails. No further verification equipment is needed before first use. The certificate covers the full 0.3 to 1.2 Nm range.
Highlights
- Precise torque control from 0.3 to 1.2 Nm
- Click-type mechanism signals when target torque is reached
- 1/4 in drive accepts replaceable bits for versatility
- Calibration certificate included for documented accuracy
- Clockwise operation suits standard fastening tasks
Specifications
| Brand | WERA |
|---|
Questions about this item
What is the lowest torque setting the 1/4 in click-type screwdriver can reliably click at?
The tool clicks from 0.3 Nm upward, with a stated resolution of 0.05 Nm for fine adjustment.
Does the handle stay comfortable and the click mechanism stay consistent during repetitive assembly work?
The click-type action gives a tactile and audible signal at the set value without motor heat or noise, and the ergonomic handle is designed for extended manual use.
Which bits fit the 1/4 in drive so the screwdriver is ready to use?
Any standard 1/4 in hex bit inserts into the replaceable bit holder; the tool ships as a handle only, so bits must be supplied separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
