Weller
Weller 50 W Solder Element 1/4" Thread On
50 W soldering iron heating element with 1/4" thread-on fitting, compatible with Weller models 7400, 7500, 7760 and 7770
- Type1/4" Thread On
- 50 W heating element delivers rapid heat-up for efficient soldering
- 1/4" thread-on design allows quick, tool-free tip changes
- Operates at 120 V for standard workshop power compatibility
- UL Listed certification confirms tested electrical safety
- Fits Weller models 7400, 7500, 7760 and 7770 for direct replacement
50 W Weller Solder Element
This 50 W heating element fits Weller soldering irons that use a 1/4 inch thread-on connection. It operates at 120 V and reaches a maximum temperature of 1,000 degrees Fahrenheit. The part is UL Listed for safety compliance. It serves as a direct replacement for worn or damaged original elements.
Replaces Elements In 7400 7500 7760 7770 Models
This element restores function to compatible Weller irons when the original heater fails or no longer reaches temperature. The upgrade is worth it when tip life drops or heat recovery slows during prolonged joints. It returns the iron to its factory 50 W rating without modification. Buyers needing higher wattage or a different thread pattern cannot use this part.
Thread-On Installation Requires Cool Iron
Installation is a simple thread-on procedure once the iron is completely cool and unplugged. Cross-threading the 1/4 inch connection is the most common error and can damage the iron housing. Overtightening may strip the soft threads or crack the ceramic core. Always verify the model number matches 7400, 7500, 7760 or 7770 before fitting.
Highlights
- 50 W heating element delivers rapid heat-up for efficient soldering
- 1/4" thread-on design allows quick, tool-free tip changes
- Operates at 120 V for standard workshop power compatibility
- UL Listed certification confirms tested electrical safety
- Fits Weller models 7400, 7500, 7760 and 7770 for direct replacement
Specifications
| Brand | Weller |
|---|---|
| Type | 1/4" Thread On |
Questions about this item
Will the 1/4" thread fit my Weller 7400 soldering iron?
Yes, the element threads directly into Weller models 7400, 7500, 7760 and 7770.
How do I install the element without damaging the threads?
Screw the element in by hand until it seats firmly, then tighten gently with a wrench; over-torquing strips the 1/4" threads.
How often will I need to replace this 50 W heating element?
Replace the element when it no longer reaches the 1,000 °F maximum temperature or shows visible pitting on the tip.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
