Weiler
Weiler 01299 Crimped Wire Wheel Brush 12 in 3600 RPM
A crimped carbon-steel wire wheel brush for bench grinders, 12 in diameter with a 1 1/4 in threaded arbor and 3,600 RPM maximum speed
- TypeSanders
- 12-inch diameter covers large surfaces quickly
- 3,600 RPM maximum speed matches bench-grinder ratings
- 006-inch carbon-steel bristles remove rust without gouging
- 2 15/16-inch bristle length reaches into corners and profiles
- 1 1/4-inch threaded arbor fits standard bench grinders
12-inch Crimped Wire Wheel Brush
This 12-inch crimped wire wheel brush is designed for bench grinders. It uses carbon steel bristles measuring 0.006 inches in diameter. The brush features a 1 1/4-inch threaded hole for secure mounting. It suits metalworkers needing surface preparation on carbon steel.
Suited for bench grinder surface prep.
This brush suits operators cleaning or deburring carbon steel using a bench grinder. The 3,600 RPM maximum speed matches standard bench grinder operation. It is not for users needing abrasive grit cutting action. Buyers requiring face widths wider than 3/4 inch should look elsewhere.
3,600 RPM maximum operating speed
The absolute speed limit is 3,600 RPM. Exceeding this rating risks bristle separation and operator injury. Verify your bench grinder no-load speed stays at or below this figure before mounting. This single specification determines whether the brush is compatible with your equipment.
Highlights
- 12-inch diameter covers large surfaces quickly
- 3,600 RPM maximum speed matches bench-grinder ratings
- 006-inch carbon-steel bristles remove rust without gouging
- 2 15/16-inch bristle length reaches into corners and profiles
- 1 1/4-inch threaded arbor fits standard bench grinders
Specifications
| Type | Sanders |
|---|---|
| Brand | Weiler |
| Model | 01299 |
Questions about this item
How hot or noisy does the 12 in crimped wire wheel get when running all day at 3600 RPM on a bench grinder?
The brush itself has no motor or bearings, so it adds no heat or electrical noise; any warmth or sound comes from the grinder spindle and the workpiece contact.
What must I already own to mount and run this 1 1/4 in threaded hole brush safely?
You need a bench grinder with a 1 1/4 in arbor thread, rated for at least 3600 RPM, plus proper guards and eye protection.
Will this 0.006 in carbon steel bristle wheel damage the softer aluminium parts I still use in my older projects?
The fine 0.006 in crimped wire is aggressive on carbon steel but can gouge aluminium; test on scrap first or choose a softer brass wheel for non-ferrous work.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
