We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Weber 70882 LED wiring harness for Summit 670 grill

weber

weber 70882 LED Wiring Harness Summit 670 BB Appliance Part

SKU CH-A74R-95Y5R

LED wiring harness for Weber Summit 670 and S-660 grills, compatible with 61 specific model numbers

  • Selling UnitEach
  • TypeGrills & Accessories
  • Direct-fit replacement for Summit 670 grills
  • Illuminates control knobs for night-time grilling
  • Compatible with 61 Weber model numbers
  • Genuine Weber part number 70882
  • New condition, ready to install

LED Wiring Harness for Summit 670 BB

This Weber 70882 LED wiring harness is a genuine appliance part designed for Summit 670 BB grill models. It restores the original LED lighting function on compatible built-in and freestanding units. The part is sold individually as a direct replacement component.

Replaces damaged or failed factory harness on 61

The harness fits Summit S-670 and S-660 models produced in 2008 and 2009, covering both LP and natural gas versions. The jump is worth it when the existing wiring is corroded, cracked or no longer illuminates the control knobs. It is not for earlier Summit series or non-LED equipped grills.

Plug-in installation matches original routing

Installation follows the factory harness path and connects to the existing LED module and control panel sockets. No tools beyond basic hand tools are typically required. What usually goes wrong is forcing connectors past alignment tabs or pinching wires during reassembly, which can cause intermittent lighting or a short circuit.

Highlights

  • Direct-fit replacement for Summit 670 grills
  • Illuminates control knobs for night-time grilling
  • Compatible with 61 Weber model numbers
  • Genuine Weber part number 70882
  • New condition, ready to install

Specifications

BrandWeber
Selling UnitEach
Part NumberWEB70882
TypeGrills & Accessories

Questions about this item

Which Summit grill models does the 70882 wiring harness fit?

The harness fits 61 Summit models including the S-670 LP and NG from 2008 and 2009, the Built-In S-660 LP and NG from 2009, and specific serial numbers such as 7360001, 7370001, 7460001, 7470001, 77360001, 77370001, 77460001 and 77470001.

How is the LED wiring harness installed on a Summit 670, and what step is often missed?

Disconnect the gas and power, remove the control panel to access the existing harness, unplug the old connectors, route the new WEB70882 harness through the same channels, and reconnect each LED plug; the step often missed is re-seating the rubber grommets so moisture cannot enter the control housing.

What maintenance or replacement will the LED wiring harness need over time?

Inspect the harness each season for cracked insulation, corroded pins or heat damage near the burners; replace the entire harness if any LED segment fails or if the connectors no longer latch securely.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.