WAWEIS
WAWEIS NS-32E440A13 AC/DC adapter 10 ft
A 10 ft AC/DC adapter with 100-240V input and multiple safety protections
- World-wide 100-240 VAC input suits global mains
- 10 ft power cord gives flexible desk placement
- FCC CE RoHS certified for regulated safety
- Over-current over-voltage short-circuit protection guards hardware
- 100 % compatible replacement for Insignia NS-32E440A13
Power input range
The WAWEIS NS-32E440A13 AC/DC adapter accepts a worldwide input of 100-240VAC at 50/60Hz. It is a direct replacement charger built for the Insignia 32" Class Slim LED model NS-32E440A13. The unit ships new and is fully compatible with the original device specifications.
Cord length and protection limits
A single 10 ft power cord gives generous reach from wall outlet to the display. Integrated safeguards include over-current, over-voltage, short-circuit and total-power protection. The adapter does not contain a battery and therefore cannot supply backup power during mains outages.
Safety certifications and build
The charger carries FCC, CE and RoHS certifications confirming compliance with recognised safety and environmental standards. High-quality wires and a smart chip provide overload, over-charge, over-discharge and overheating protection. Anti-interference isolation materials further stabilise operation under normal load.
Highlights
- World-wide 100-240 VAC input suits global mains
- 10 ft power cord gives flexible desk placement
- FCC CE RoHS certified for regulated safety
- Over-current over-voltage short-circuit protection guards hardware
- 100 % compatible replacement for Insignia NS-32E440A13
Specifications
No published specifications for this item yet.
Questions about this item
Will the 10 ft cord reach a wall socket behind my desk while the 32" Insignia NS-32E440A13 stays on its stand?
The cable is 10 ft long, giving plenty of slack to route from a floor or wall outlet to the display without tension.
How can I confirm the adapter is delivering stable power to the NS-32E440A13 after plugging it in?
The unit powers the display normally; built-in over-current, over-voltage and short-circuit protection shut it down if anything drifts out of spec.
Does the box include only the adapter brick and the 10 ft mains lead, or must I buy a separate IEC cable?
The 10 ft cord is permanently attached to the brick, so the single piece in the box is the complete charger — no extra cable is needed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Kensington Desk Mount Cable Anchor K64613WW accessory
- Black
- Provides a secure a…
Panasonic CF-VDR291U laptop cooling pad
- Optical Drive
- Buffer Size: 2 MB B…
eReplacements PB992A-ER laptop battery 14.4V
- Battery
- Lithium-Ion



